Mailinglist Archive: opensuse (2974 mails)

[Matthew <matthew@xxxxxxxxxxxxxxx>]

Can you fully list out your components? I want to know what hde is
exactly...

Also, in your BIOS what pnp settings did you set?

Matt

On Wed, 7 Feb 2001 schutt@xxxxxxxxxxx wrote:

> Hi.
>
> I've just tried to install linux for the first time, using Yast2 from Suse 7.0,
> and my system won't quite boot up all the way.  During the boot
> process I get a message that says:
>
>   ATAPI device hda:
>     Error: Not ready -- (Sense key=0x02)
>     (reserved error code) -- (asc0x3a, ascq=0x01)
>     The failed "Read Cd/Dvd Capacity" packed was:
>     [some numbers here]
>
> After this error, some normal looking stuff happens, then
> I get repeatedly:
>
>   hde: lost interrupt
>
> and the system stalls, just repeatedly displaying the "lost interrupt" message.
>
> My system (which runs fine on windows)
>   K7 1000 Mhz (thunderbird)
>   Plextor CDRW 12x/10x/32x
>   Abit KT7A-RAID
>   IBM Deskstar 45 GB 7200rpm
>   Asus GeForce MX
>
>   Suse 7.0, booting from floppy
>   hard drive repartitioned using "fips" (apparently sucessfully)
>
> My first thought was that the CDRW or the KT7A-Raid didn't yet have linux drivers,
> but they both work under Red Hat according to www.linhardware.org.
>
> Can anyone help me?  I don't know what to do now.  And with the Oakland lay-offs,
> it doesn't look like I'm going to get any installation support.
>
> TIA,
>
> Derek
>
>
>
>
>
>
> --
> To unsubscribe send e-mail to suse-linux-e-unsubscribe@xxxxxxxx
> For additional commands send e-mail to suse-linux-e-help@xxxxxxxx
> Also check the FAQ at http://www.suse.com/support/faq
>
>