Jesse Marlin wrote:
wulfie writes:
you need to add the glx module to XF86Config - you can do this via SaX (load current config, edit actual config, add module glx) or manually add " Load glx". Check the SDB on using 3D-accel with SuSE, it's all in there.
He says he is using 3.3.6 which does not have support for GLX except through some special servers. The best thing to do is to upgrade to Xfree86-4.01 which you can find on SuSE's website. Then add the "glx" module as hinted above.
From my X startup
XFree86 Version 3.3.5 / X Window System (protocol Version 11, revision 0, vendor release 6300) Release Date: August 23 1999 If the server is older than 6-12 months, or if your card is newer than the above date, look for a newer version before reporting problems. (see http://www.XFree86.Org/FAQ) Operating System: Linux 2.2.13 i686 [ELF] SuSE Configured drivers: [...] Sucessfully loaded XFree86 3.3 symbols GLX extension module for XFree86 3.3.3.1 -- Mesa version 3.2 GLX package version 0.9, GLX protocol version 1.2. (**) module /usr/local/lib/glx.so successfully loaded (**) FontPath set to "/usr/X11R6/lib/X11/fonts/75dpi:unscaled,/usr/X11R6/lib/X11 /fonts/100dpi:unscaled,/usr/X11R6/lib/X11/fonts/Type1,/usr/X11R6/lib/X11/fonts/m isc,/usr/X11R6/lib/X11/fonts/japanese,/usr/X11R6/lib/X11/fonts/75dpi,/usr/X11R6/ lib/X11/fonts/100dpi,/usr/X11R6/lib/X11/fonts/Speedo,/usr/X11R6/lib/X11/fonts/Ja panese-BIG" (--) SVGA: PCI: Matrox MGA G200 AGP rev 3, Memory @ 0xf6000000, 0xf7800000, MMIO @ 0xf77fc000 It can work; you just need the time and patience to make , with the emphasis on patience. Jim -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/support/faq