Mailinglist Archive: opensuse (2522 mails)
| < Previous | Next > |
Re: [SLE] Bad magic
- From: bernie@xxxxxxxxxxxxxxxxxxxxxxx (Bernd Felsche)
- Date: Tue, 4 Jul 2000 22:51:25 +0800 (WST)
- Message-id: <200007041451.WAA11900@xxxxxxxxxxxxxxxxxxxxxxxxxxxxxxxx>
Chris.Smith@xxxxxxxxxxxxxx tapped away at the keyboard with:
> ** I am also getting this error on a couple of 'low spec' machines (P90, 8Mb
> ** Ram), I am putting it down to lack of memory, because it does not happen if
> ** I double the memory.
> **
> ** I go around it but putting 64Mb ram in the machine, installing and setting
> ** the box up, and then removing the memory. Bad work around, but it works...
> SuSE is a sod on low mem systems. It won't install via FTP on my
> 16Mb P60 firewall at all. YaST also struggles a tad. I'd say
> that 32M is probably a good minimum as 8-16Mb makes it painful
> and causes ppp to dump all the time in my experience. My
> normal workstation has 256M of RAM in it and that stil swaps
> sometimes :-P
Having been able to install on a 486DX??? machine with 8MB, with the
installation over NFS from another SuSE box on a LAN, I can say
that it is all achievable with a degree of patience. It all seems
much more painful while watching... :-)
A minimal setup takes about 40 minutes but as it runs unattended, no
big deal. Go for a meal break. Just be sure to set up swap manually
at the beginning. A 16MB system with similar CPU (P90 perhaps)
installed in about 15 minutes off the same "server".
More memory would help; there's a low-memory thrashing problem for
which a patch was posted here recently. The RPM should be available
soon according to the announcement.
If you're trying to do this over ppp, you should expect a slightly
longer installation time. The memory-thrashing may have come into
play there.
--
Bernd Felsche - Innovative Reckoning
Perth, Western Australia
--
To unsubscribe send e-mail to suse-linux-e-unsubscribe@xxxxxxxx
For additional commands send e-mail to suse-linux-e-help@xxxxxxxx
Also check the FAQ at http://www.suse.com/support/faq
| < Previous | Next > |