Same as NT and Windows 98 and Windows 95 and DOS....... Just configure LILO to boot from the hard drive your Win2k installation is on. If your Win2k installation was on the first partition of the primary master hard drive then select /dev/hda1 If it is on the first partition of your secondary slave (as you said, hdd) then point it to /dev/hdd1. Kev
-----Original Message----- From: john [mailto:john@jmtl.com] Sent: 27 June 2000 13:02 To: Suse-Linux-E Subject: [SLE] Dual booting Linux & Win2000
Hello folks,
Does anyone know how to configure lilo (and Win2000) so that I can dual boot between Linux and Windows 2000, in my specific case, where the two are on separate disks (hdc for linux & hdd for win2000) ?
The Multiboot-with-LILO Howto covers win98 and winNT, but has no windows 2000 details as yet.
Help!
Thanks,
John
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/