Hi Nadeem Yes, I am using xfstt. It is loaded in boot.local. Maybe I should put it somewhere else? Steve. On Sat, 06 May 2000, you wrote:
Hi, Are you using xfsft (or xfstt) by any chance? Its quite possible that switching to "S" causes it to shutdown but switching back to "2" does not bring it up again. Check your rc scripts. With "1", its possible that switching to it does not kill the font server, so switching back to 2 is not a problem.
Thanks, Nadeem
Hi everyone.
Small problem after 6.4 upgrade.
Switching to init S and then back to init 2 will not allow me to do a start x. One of the fonts is missing:
Cannot connect fatal server error could not open default font 'fixed'
and I have to do a normal reboot to get the X serbver up again.
Question: This does not happen if I do init 1 instead of init S. Does init 1 serve the same purpose as init S? If so, then this is the workaround.
Thanks, Steve.
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/