Getting a prompt of 'LI' sounds familiar. I found that it was because LILO had not been properly configured and could not find the boot sector. Try YaST to rebuild LILO. Good luck, Bill Barnes
===== Original Message From Cliff Pankonien
===== Hello, all; I recently installed 6.4 on an AMD K62-450 with two ide drives, a 4 gig and a 1.5 gig. When I reboot I get the LI prompt, I can boot using the boot disk and booting from hda2 (hda1 being the swap partition). When I run /usr/sbin/lilo, I get the following error - Hole found in map file (alloc_page). I also got this same error when doing the initial installation. Any ideas? Thanks,
Cliff Pankonien jackdaw@jackdaw.net
-- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/
------------------------------------------------------------ This e-mail has been sent to you courtesy of OperaMail, a free web-based service from Opera Software, makers of the award-winning Web Browser - http://www.operasoftware.com ------------------------------------------------------------ -- To unsubscribe send e-mail to suse-linux-e-unsubscribe@suse.com For additional commands send e-mail to suse-linux-e-help@suse.com Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/