Mailinglist Archive: opensuse (2234 mails)

[juergen.braukmann@xxxxxxxxxxxx (Juergen Braukmann)]

Hi Kevin,

have a look at /sbin/init.d/serial
This is the serial port setting script. Most stuff is commented, but
you'll find standard settings for ttyS0-ttyS3 that can be altered to
your settings you mentioned below.

Juergen

klcroxen@xxxxxxxxxxxxxxx wrote:
> 
> I have a peripheral that needs to operate at com3, irq9. Currently,
> to enable it under Linux, after booting I need to issue the command
> setserial /dev/ttyS2 irq 9 port 0x3e8
> 
> Needless to say I would prefer that ttyS2 initialize at irq 9 as part of
> the boot process, but I can't seem to figure out how to put it there.
> 
> Can anyone give me a hand?
> 
> Thanks,
> 
> --Kevin
> 


-- 
==========================================     __   _
Juergen Braukmann mail: brauki@xxxxxxxxxx| -o)/ /  (_)__  __ ____  __
Tel: 0201-743648  dk4jb@db0qs.#nrw.deu.eu| /\\ /__/ / _ \/ // /\ \/ /
==========================================_\_v __/_/_//_/\_,_/ /_/\_\

-- 
To unsubscribe send e-mail to suse-linux-e-unsubscribe@xxxxxxxx
For additional commands send e-mail to suse-linux-e-help@xxxxxxxx             
Also check the FAQ at http://www.suse.com/Support/Doku/FAQ/