Hi, I've installed Suse 9.1 on a Dell Inspiron 8600 (with ATI Mobility Radeon 9600 PRO Turbo card and 1920x1200 laptop display panel). Sax2 wouldn't recognize the 1900x1200 panel, so I googled a bit and managed to put together an XF86Config file (attached) that works quite well using the unaccelerated "radeon" driver. Then I decided to install the latest version of the ATI 3.9.0 driver available from Suse's ftp site following instructions in the README. Driver installs successfully, however when I run "sax2 -r -m 0=fglrx -b /usr/X11R6/lib/sax/profile/firegl", the screen goes blank, then parts of the screen go white, then green, :-) , at which moment I usually kill Sax with Ctrl-Shift-Backspace, and it exists generating the attached log file. The log says a) "DRI initialization failed"; and b) there are lots of unresolved symbols. I've already fixed error messages about MTRR overlaps using instructions from http://odin.prohosting.com/wedge01/gentoo-radeon-faq.html#4_mtrroverlap. I'd appreciate any suggestions. These are the relevant (I think) package versions: fglrx-3.9.0-2.1 km_fglrx-3.9.0-2.1 kernel-source-2.6.5-7.95 kernel-default-2.6.5-7.95 Regards, Vadym ********************************************************************** This email and any files transmitted with it are confidential and intended solely for the use of the individual or entity to whom they are addressed. Any unauthorized review, use, disclosure or distribution is prohibited. If you are not the intended recipient, please contact the sender by reply e-mail and destroy all copies of the original message.