Mailinglist Archive: opensuse-security (137 mails)
| < Previous | Next > |
Re: [suse-security] Bug in Susefirewall FW_ALLOW_INCOMING_HIGHPORTS_UDP
- From: Ludwig Nussel <ludwig.nussel@xxxxxxx>
- Date: Tue, 28 Jun 2005 15:36:02 +0200
- Message-id: <20050628133602.GA2481@xxxxxxx>
Frank Stuehmer wrote:
> just tried to use fresh installed Suse 9.3 updated with you.
>
> SuSEfirewall2-3.3-18.2
>
> /etc/sysconfig/SuSEfirewall2
> with FW_ALLOW_INCOMING_HIGHPORTS_UDP="yes"
>
> Start FW complains, four lines
> "iptables: No chain/target/match by that name"
>
> Reasons are in /sbin/SuSEfirewall
> lines 1460 and 1469:
> for CHAIN in $input_zones; do
> --> chain=input_$chain
>
> should be "CHAIN=input_$CHAIN".
Thanks for the report. I've prepared an update, it will take a bit
until it appears in YOU though.
Btw, what's your use case for this variable? I was actually thinking
about dropping it.
cu
Ludwig
--
(o_ Ludwig Nussel
//\ SUSE LINUX Products GmbH, Development
V_/_ http://www.suse.de/
> just tried to use fresh installed Suse 9.3 updated with you.
>
> SuSEfirewall2-3.3-18.2
>
> /etc/sysconfig/SuSEfirewall2
> with FW_ALLOW_INCOMING_HIGHPORTS_UDP="yes"
>
> Start FW complains, four lines
> "iptables: No chain/target/match by that name"
>
> Reasons are in /sbin/SuSEfirewall
> lines 1460 and 1469:
> for CHAIN in $input_zones; do
> --> chain=input_$chain
>
> should be "CHAIN=input_$CHAIN".
Thanks for the report. I've prepared an update, it will take a bit
until it appears in YOU though.
Btw, what's your use case for this variable? I was actually thinking
about dropping it.
cu
Ludwig
--
(o_ Ludwig Nussel
//\ SUSE LINUX Products GmbH, Development
V_/_ http://www.suse.de/
| < Previous | Next > |