Re: [suse-security] KLIPS on IPSec won't start up properly

Mark Tinka: wrote

i have just installed IPSec, on SuSE and when i start the daemon, i get this error message:ipsec_setup:

try "echo 1 > /proc/sys/net/ipv4/conf/ipsec0/rp_filter" should work

WARNING: ipsec0 has route filtering turned on, KLIPS may not work ipsec_setup: (/proc/sys/net/ipv4/conf/ipsec0/rp_filter = `1', should be 0) ipsec_setup: WARNING: eth0 has route filtering turned on, KLIPS may not work ipsec_setup: (/proc/sys/net/ipv4/conf/eth0/rp_filter = `1', should be 0)

i have had a look at these files ????????? for the ipsec0 and

eth0 interfaces, but changing the metric is not possible when they interface is up.. and writing the file isn't possible when the interface is down... any ideas would be appreciated.. thanks..

AKNIT