Hello,
It's just a guess, but I noticed you are specifying slot number 11 in the
chhwres command. The HMC defaults to only 10 virtual slots when you
create a new partition, so you might be out of range on the slot ID.
Either use a number smaller than 10 or add more virtual slots via the HMC
for this partition.
Good luck,
Robert
Ingvar Hagelund
Sent by: ingvar@true.linpro.no
11/01/2005 04:30 PM
To
suse-ppc@suse.com
cc
Subject
[suse-ppc] dlpar on sles9/openpower
We have an IBM OpenPower 720 with hypervisor and a set of
lpars. Earlier we got dlpar to work, at least a couple of times, but
not anymore. Here's an example:
Ran this on the hmc:
~> chhwres -r virtualio -m Server-9124-720-SNXXXXXXX -p mgmt -o a \
--rsubtype eth -s 11 \
-a
"ieee_virtual_eth=1,port_vlan_id=1,is_trunk=1,\"addl_vlan_ids=600,601\""
HSCL294C DLPAR ADD Virtual I/O resources failed: HMC adding Virtual I/O
......
HMC Virtual slot DLPAR operation failed. Here are the virtual slot IDs
that failed and the reasons for failure:
11 The dynamic logical partitioning operation failed.
On the lpar "mgmt", running sles9 sp2 kernel 2.6.5-7.193-pseries64, we
have the magic rpms from IBM installed:
evlog-drv-tmpl-0.8-1
diagela-1.3.0.0-6
lsvpd-0.12.7-1
ppc64-utils-2.5-2
librtas-1.2-1
and the following IBM services are running:
# lssrc -a
Subsystem Group PID Status
ctrmc rsct 5011 active
IBM.ServiceRM rsct_rm 5103 active
IBM.DRM rsct_rm 5110 active
IBM.HostRM rsct_rm 5186 active
IBM.CSMAgentRM rsct_rm 5217 active
IBM.ERRM rsct_rm 5221 active
IBM.AuditRM rsct_rm 5266 active
ctcas rsct 7705 active
IBM.SensorRM rsct_rm 7721 active
IBM.FSRM rsct_rm 7722 active
IBM.ConfigRM rsct_rm 7723 active
So, where can I start digging?
Regards,
Ingvar
--
Many that live deserve death. And some that die deserve life. Can you
give it to them? Then do not be too eager to deal out death in
judgement. For even the very wise cannot see all ends.
Gandalf
