Hi there. I am having difficultly installing the 4 CD distribution of SuSE Linux 6.4 on my Umax C600 Mac clone, essentially a PowerPC 603e. The installation appears to proceed normally until YaST1 terminates and (presumably) control is handed over to the newly installed kernel, at which point I get . . Starting Name Service Cache Daemon..... FAILED! . . I'm not sure what this means but I can still log in. The real problem arises when I restart or boot up from the internal ATA hard drive, (onto which Linux has just been installed. I have MacOS 9 on a SCSI drive). I get as far as . . Loading Menstat Module... . . at which point it says . . It seems that the last installation was not complete. To be sure it will be started again... . . and YaST1 fires up once more. If I then exit YaST1 as quickly as possible the boot up process continues, and this time I get . . Starting Name Service Cache Daemon..... DONE . . and everything's fine. Any suggestions as to what to do to avoid YaST1 each time I boot up would be much appreciated. Seb Tennant.