Hi all, I've got ppp working using kppp now but am still having trouble with dual booting. It seems that I can get either os-chooser to be tbxi or yaboot to be tbxi but not both at the same time (is this what's supposed to happen?). If I make my boot partition the start up disk with os-chooser being tbxi then I get a flashing question mark.. If I do the same except with yaboot being tbxi then I get a boot: prompt but if I type "linux", or anything else for that matter, it just returns to a new line and gives me the boot: prompt again. I followed the manual's instructions carefully:- 1) put suseboot on my boot (HFS) partition. 2) made that partition the startup disk. 3) booted into linux from cd1 4) edited (as root) lilo.conf - then ran lilo (I double checked I had set the correct address for the boot partition, this seemed to work perfectly) 5) rebooted and got a flashing question mark... this my os-chooser boot script:- <BOOT-SCRIPT> " get-key-map" " keyboard" open-dev $call-method dup 20 dump 5 + c@ 08 = if " Booting MacOS ..." cr " boot hd:5,\\:tbxi" eval else " Booting Yaboot ..." cr " boot ultra1:8,\\yaboot" eval then </BOOT-SCRIPT> and this is my yaboot.conf :- timeout = 100 default = linux image = ultra1:10,/boot/vmlinux label = linux root = /dev/hdb10 append = "load_ramdisk=1 " Here's my partition tables (at least the relevant partitions) as I understand them to be:- MacOs /dev/hda5 boot /dev/hdb8 root /dev/hdb10 swap /dev/hdb9 I'm using a blue & white G3 with MacOs 8.6 Should I be using bootx? is that even possible on a ppc? any help with this would be much appreciated . -- - ____________________________ - Jonathon Wallen - B,DES College of Fine Arts, UNSW - z2213441@student.unsw.edu.au - ____________________________