Hi, I have one adsl router and two accounts, one a local only account with a 200 gig cap and one international with a meager 3 gig cap. I set up a routing table which actually works if I use a wireless card wlan0 as well as eth0 but I cannot get it to work with either two dsl pppoe devices or one dsl0 and eth0. The problem is as soon as I ifup dsl0 (the local only account) it prevents any other device access to the outside world, if I ifup dsl1, which is setup for the international account, when dsl0 is active it prevents dsl0 from accessing the internet. Ie. whichever dsl device starts last is the only one that is used. Output from ifstatus dsl0 when in use :- # ifstatus dsl0 dsl0 name: DSL Connection interface dsl0 is up provider-file: provider0 status: connected demand: no Output from ip route ls when dsl0 in use :- # ip route ls 41.185.102.1 dev dsl0 proto kernel scope link src 41.185.102.141 10.0.0.0/24 dev eth0 proto kernel scope link src 10.0.0.54 169.254.0.0/16 dev eth0 scope link 127.0.0.0/8 dev lo scope link default dev dsl0 scope link # cat /etc/sysconfig/network/routes 41.0.0.0/11 - - dsl0 41.32.0.0/11 - - dsl0 41.96.0.0/16 - - dsl0 196.0.0.0/8 - - dsl0 41.64.0.0/11 - - dsl0 default 10.0.0.2 - eth0 I've asked on the opensuse list and haven't got further than I am today. I would appreciate someone explaining either why this can't work under linux or what I am doing wrong. There is an MS windows program called route sentry that allegedly does exactly what I am trying to do so I'm sure this must be possible. Thanks in advance. Dave P -- To unsubscribe, e-mail: opensuse-networking+unsubscribe@opensuse.org For additional commands, e-mail: opensuse-networking+help@opensuse.org