Hallo, ich habe ein Problem beim auslesen meiner Epson PhotoPC 2100Z an USB. Zwar wird die Kamera richtig erkannt und auch eingetragen, allerdings wird die Commpact-Flash-Card nicht richtig erkannt. folgende Meldung: -----zip----- Apr 25 15:41:35 linux kernel: hub.c: USB new device connect on bus1/2, assigned device number 2 Apr 25 15:41:35 linux kernel: usb.c: USB device 2 (vend/prod 0x4b8/0x605) is not claimed by any active driver. Apr 25 15:41:35 linux kernel: Initializing USB Mass Storage driver... Apr 25 15:41:35 linux kernel: usb.c: registered new driver usb-storage Apr 25 15:41:35 linux kernel: scsi1 : SCSI emulation for USB Mass Storage devices Apr 25 15:41:35 linux kernel: Vendor: EPSON Model: PhotoPC 2100Z Rev: 1.00 Apr 25 15:41:35 linux kernel: Type: Direct-Access ANSI SCSI revision: 02 Apr 25 15:41:35 linux kernel: Attached scsi removable disk sda at scsi1, channel 0, id 0, lun 0 Apr 25 15:41:35 linux kernel: SCSI device sda: 93953 512-byte hdwr sectors (48 MB) Apr 25 15:41:35 linux kernel: sda: Write Protect is off Apr 25 15:41:35 linux kernel: sda: sda1 Apr 25 15:41:35 linux kernel: WARNING: USB Mass Storage data integrity not assured Apr 25 15:41:35 linux kernel: USB Mass Storage device found at 2 Apr 25 15:41:35 linux kernel: USB Mass Storage support registered. Apr 25 15:41:35 linux insmod: Using /lib/modules/2.4.18-4GB/kernel/drivers/usb/storage/usb-storage.o Apr 25 15:41:35 linux insmod: Symbol version prefix '' Apr 25 15:41:35 linux kernel: VFS: Disk change detected on device sr(11,0) Apr 25 15:41:35 linux kernel: VFS: Disk change detected on device sr(11,0) Apr 25 15:41:36 linux kernel: usb-uhci.c: interrupt, status 2, frame# 1576 Apr 25 15:41:36 linux kernel: Device 08:00 not ready. Apr 25 15:41:36 linux kernel: I/O error: dev 08:00, sector 0 Apr 25 15:41:36 linux kernel: Device not ready. Make sure there is a disc in the drive. Apr 25 15:41:36 linux kernel: VFS: Disk change detected on device sd(8,0) Apr 25 15:41:36 linux kernel: sda : READ CAPACITY failed. Apr 25 15:41:36 linux kernel: sda : status = 1, message = 00, host = 0, driver = 08 Apr 25 15:41:36 linux kernel: Current sd00:00: sns = 70 2 Apr 25 15:41:36 linux kernel: ASC=3a ASCQ= 0 Apr 25 15:41:36 linux kernel: Raw sense data:0x70 0x00 0x02 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00 0x00 0x3a 0x00 0x00 0x00 0x00 0x00 Apr 25 15:41:36 linux kernel: sda : block size assumed to be 512 bytes, disk size 1GB. Apr 25 15:41:36 linux kernel: sda: I/O error: dev 08:00, sector 0 Apr 25 15:41:36 linux kernel: I/O error: dev 08:00, sector 0 Apr 25 15:41:36 linux kernel: unable to read partition table Apr 25 15:41:36 linux kernel: Device not ready. Make sure there is a disc in the drive. ----zip----- hat jemand einen Tip? Reinhold