Hallo, ich bekomme mein WLAN nicht zum laufen. Hab nun schon folgendes gemacht: Die WLAN-karte wurde vom System erkannt und auch der Prism54 Teiber korrekt eingebunden. Hier ein Auszug von #hwinfo --netcard 29: PCI 306.0: 0282 WLAN controller [Created at pci.277] UDI: /org/freedesktop/Hal/devices/pci_1260_3890 Unique ID: JNkJ.Z7e7L9Q6ex5 Parent ID: 6NW+.c7JTK_YUBi2 SysFS ID: /devices/pci0000:00/0000:00:1e.0/0000:03:06.0 SysFS BusID: 0000:03:06.0 Hardware Class: network Model: "Z-Com XG-600 and clones Wireless Adapter" Vendor: pci 0x1260 "Intersil Corporation" Device: pci 0x3890 "Intersil ISL3890 [Prism GT/Prism Duette]" SubVendor: pci 0x17cf "Z-Com, Inc." SubDevice: pci 0x0014 "Z-Com XG-600 and clones Wireless Adapter" Revision: 0x01 Driver: "prism54" Device File: eth1 Features: WLAN Memory Range: 0xd2004000-0xd2005fff (rw,non-prefetchable) IRQ: 11 (no events) Module Alias: "pci:v00001260d00003890sv000017CFsd00000014bc02sc80i00" Driver Info #0: Driver Status: prism54 is active Driver Activation Cmd: "modprobe prism54" Config Status: cfg=no, avail=yes, need=no, active=unknown Attached to: #17 (PCI bridge) Mein Laptop hat zudem noch eine Taste mit der ich die WLAN-Karte in Betrieb nehmen kann. Dazu habe ich das Modul acerhk installiert und mit dem Kommando # echo on > /proc/driver/acerhk/wirelessled Lässt sich die WLAN-Karte aktivieren. Die hierfür zuständige Led leuchtet. Es sollte soweit eigentlich alles bestens sein. Jedoch ein Aufruf von # ifup eth0 bringt mir diese Fehlermeldung: eth1 device: Intersil Corporation Intersil ISL3890 [Prism GT/Prism Duette] (rev 01) eth1 configuration: wlan-bus-pci-0000:03:06.0 eth1 warning: using NO encryption SIOCSIFFLAGS: No such file or directory ERROR: Cannot enable interface eth1. ERROR: interface eth1 is not up SuSEfirewall2: Warning: ip6tables does not support state matching. Extended IPv6 support disabled. SuSEfirewall2: Setting up rules from /etc/sysconfig/SuSEfirewall2 ... SuSEfirewall2: Warning: no interface active SuSEfirewall2: batch committing... SuSEfirewall2: Firewall rules successfully set Kann jemand damit was anfangen und mir sagen was hier schief gelaufen ist. Vielen Dank schon mal im Voraus Manfred Theuermann