Mailinglist Archive: opensuse-mobile-de (151 mails)

[Frans Leerink <f.leerink@xxxxxxxxx>]

In Suse 9.2 and 9.3 wireless worked correctly. Wired or Wireless choosen 
via Profiles set up in Profile Management.

I have know installed Suse Linux 10.0, configured in the same way the 
network cards  with module prim54 and set up the Profile management but 
the wireless card is not working.

After I have selected profile Wireless the command Iwconfig shows that eth2 
is the only wireless device. (IEEE 802.11b/g, Mode:Managed, Frequency 
20452 GHz,  Access Point 00.00.00.00.00.00)

The command if config shows eth2 with proper hw address, IP address  and 
also lo the loopback.

The command ifdown eth2 shows device: Intersil Corporation Intersil ISL3890 
[PrismGT/PrismDuette], Configuration: wlan-id-<mac-address-wireless-card>

The command ifup eth2 shows again device:...   and configuration ...
followed by : starting WPA-supplicant WPA_driver_prism54_set_coutermeasure 
----- Not yet implemented.

I don't know what this means since I use WEP and Not WPA.

The only strange thing during network configuration was that I could not 
select my wireless network card out of the displayed list under hardware 
details nor was I able to search for it. The system  came allways with 
other cards and modules. Never with my card and module name prism54.

What can I do now, besides reinstall 9.3
-- 

Regards,

	Frans Leerink