December 2013 - openSUSE KDE 3 - openSUSE Mailing Lists

[opensuse-kde3] openSUSE 12.1 with KDE3 and KDE4 applications
by Gianluca Interlandi 05 May '15

05 May '15

Hi! I am about to install openSUSE 12.1 on a laptop. I want to use it mainly (or entirely) with the KDE3 desktop but I still want to be able to run KDE4 applications under KDE3. In the past, I have done this with openSUSE 11.3 and 11.4. During installation of 11.3 and 11.4, I selected KDE4 as the default desktop. Then I added the KDE:KDE3 repository and installed all the packages to properly run KDE3 following more or less the recommendations given here: HOW-TO: KDE 3.5 on 11.4 This has worked perfectly and I was even able to use the oxygen theme in KDE3. For example, okular and vlc came with the nice oxygen theme even when running under KDE3. My question is: Is this procedure going to work also with openSUSE 12.1 or is there anything in particular I have to pay attention to? Thanks! Gianluca -- To unsubscribe, e-mail: opensuse-kde3+unsubscribe(a)opensuse.org To contact the owner, e-mail: opensuse-kde3+owner(a)opensuse.org

6 9

[opensuse-kde3] Problems with screensavers
by Chika 20 Feb '14

20 Feb '14

Actually, this appears to be a problem that has been an increasing pain since I first ran across it in V12.1. The symptoms go a bit like this. When I try to open the screensaver settings from the "Configure Desktop" right-click option, the window opens for a couple of seconds, showing "Loading..." in the screensaver selection area. It will then crash with no visible error and take the entirety of the desktop with it. The only fix I have to hand at that point is to restart the session. If I try to do the same thing from the control centre, it does almost exactly the same thing except that it doesn't take the desktop with it. I suspect the fault is the same one but the fact that the screensaver setup page is embedded in another program means that it doesn't get a chance to kill the desktop. I have now built KDE3 on openSUSE 13.1 four different times, both by overlaying it on KDE4 or building it on a minimal X Window build, and I have used different systems to do it on, though on each occasion this has been on VirtualBox systems. The only other clue I have to hand is that the kio_sysinfo slave comes up with "Process for the sysinfo protocol died unexpectedly" error when I try to use that (which is very annoying and, before anyone says it, NO I do NOT want to use that overstuffed "infocenter" thing!) Any clues? Ta -- Chika -- To unsubscribe, e-mail: opensuse-kde3+unsubscribe(a)opensuse.org To contact the owner, e-mail: opensuse-kde3+owner(a)opensuse.org

5 5

[opensuse-kde3] kde3 for openSUSE 12.2 is frozen
by Ilya Chernykh 11 Dec '13

11 Dec '13

Kde3 for openSUSE 12.2 is frozen. No updates will be made to the repository so to save build power. -- To unsubscribe, e-mail: opensuse-kde3+unsubscribe(a)opensuse.org To contact the owner, e-mail: opensuse-kde3+owner(a)opensuse.org

1 0

[opensuse-kde3] automount of USB disk in openSUSE 12.3 / KDE3
by Istvan Gabor 04 Dec '13

04 Dec '13

Hello: openSUSE 12.3 with KDE3 hal-enabled kdebase3 packages. When I plug in an USB stick, nothing happenes on the desktop, no notifier, no automounting. dmesg indicates the medium is recognized: [ 728.028033] usb 1-1: new high-speed USB device number 2 using ehci_hcd .. [ 728.209966] Initializing USB Mass Storage driver... [ 728.215480] scsi4 : usb-storage 1-1:1.0 [ 728.215800] usbcore: registered new interface driver usb-storage [ 728.215804] USB Mass Storage support registered. .. [ 729.255197] sd 4:0:0:0: Attached scsi generic sg4 type 0 [ 729.627164] sd 4:0:0:0: [sde] 15687680 512-byte logical blocks: (8.03 GB/7.48 GiB) [ 729.627650] sd 4:0:0:0: [sde] Write Protect is off [ 729.627656] sd 4:0:0:0: [sde] Mode Sense: 23 00 00 00 [ 729.628161] sd 4:0:0:0: [sde] No Caching mode page present [ 729.628165] sd 4:0:0:0: [sde] Assuming drive cache: write through [ 729.632704] sd 4:0:0:0: [sde] No Caching mode page present [ 729.632717] sd 4:0:0:0: [sde] Assuming drive cache: write through [ 729.661277] sde: sde1 [ 729.663675] sd 4:0:0:0: [sde] No Caching mode page present [ 729.663683] sd 4:0:0:0: [sde] Assuming drive cache: write through [ 729.663690] sd 4:0:0:0: [sde] Attached SCSI removable disk How can I fix it? Thanks, Istvan -- To unsubscribe, e-mail: opensuse-kde3+unsubscribe(a)opensuse.org To contact the owner, e-mail: opensuse-kde3+owner(a)opensuse.org

7 34