Mailinglist Archive: opensuse-isdn-de (178 mails)

< Previous Next >
Re: [suse-isdn] Einwahlserver unter Suse 8.2
  • From: <thomas.harms@xxxxxxxx>
  • Date: Mon, 16 Feb 2004 17:16:43 +0000 (UTC)
  • Message-id: <200402161714.i1GHEqQ32322@xxxxxxxxxxxxxxxxxxxx>
Hallo Herr Keil,

hier noch ein paar Daten,

PDC:~ # ifconfig -a
eth0 Link encap:Ethernet HWaddr 00:0B:CD:C9:AE:15
inet addr:192.168.0.1 Bcast:192.168.0.255 Mask:255.255.255.0
inet6 addr: fe80::20b:cdff:fec9:ae15/64 Scope:Link
UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1
RX packets:4329088 errors:0 dropped:0 overruns:0 frame:0
TX packets:3828989 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
RX bytes:1533176983 (1462.1 Mb) TX bytes:1343176673 (1280.9 Mb)

ippp0 Link encap:Point-to-Point Protocol
inet addr:192.168.0.2 P-t-P:192.168.0.3 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

ippp1 Link encap:Point-to-Point Protocol
inet addr:192.168.0.2 P-t-P:192.168.0.3 Mask:255.255.255.255
UP POINTOPOINT RUNNING NOARP MTU:1500 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

lo Link encap:Local Loopback
inet addr:127.0.0.1 Mask:255.0.0.0
inet6 addr: ::1/128 Scope:Host
UP LOOPBACK RUNNING MTU:16436 Metric:1
RX packets:511994 errors:0 dropped:0 overruns:0 frame:0
TX packets:511994 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
RX bytes:2917827910 (2782.6 Mb) TX bytes:2917827910 (2782.6 Mb)

sit0 Link encap:IPv6-in-IPv4
NOARP MTU:1480 Metric:1
RX packets:0 errors:0 dropped:0 overruns:0 frame:0
TX packets:0 errors:0 dropped:0 overruns:0 carrier:0
collisions:0
RX bytes:0 (0.0 b) TX bytes:0 (0.0 b)

also sieht so aus als ob sie gestartet sind :-))


PDC:~ # isdnctrl list all

Current setup of interface 'ippp0':

EAZ/MSN: 27
Phone number(s):
Outgoing: 00
Incoming:
Dial mode: manual
Secure: on
Callback: off
Reject before Callback: on
Callback-delay: 2
Dialmax: 1
Hangup-Timeout: 300
Incoming-Hangup: off
ChargeHangup: on
Charge-Units: 0
Charge-Interval: 0
Layer-2-Protocol: hdlc
Layer-3-Protocol: trans
Encapsulation: syncppp
Slave Interface: None
Slave delay: 10
Master Interface: None
Pre-Bound to: Nothing
PPP-Bound to: 0

Current setup of interface 'ippp1':

EAZ/MSN: 28
Phone number(s):
Outgoing: 00
Incoming:
Dial mode: manual
Secure: on
Callback: off
Reject before Callback: on
Callback-delay: 2
Dialmax: 1
Hangup-Timeout: 300
Incoming-Hangup: off
ChargeHangup: on
Charge-Units: 0
Charge-Interval: 0
Layer-2-Protocol: hdlc
Layer-3-Protocol: trans
Encapsulation: syncppp
Slave Interface: None
Slave delay: 10
Master Interface: None
Pre-Bound to: Nothing
PPP-Bound to: 1

muss bei dem ippp0 nicht das Secure="OFF" sein, wenn ich keine liste mit Nummern habe die anrufen dürfen ??

Gruss
Thomas


Karsten Keil <kkeil@xxxxxxx> schrieb am 16.02.04 17:11:19:

On Mon, Feb 16, 2004 at 04:12:30PM +0100, thomas.harms@xxxxxxxx wrote:
> Hallo,
>
> habe alle Daten noch einmal eingegeben. jetzt bekomme ich bei der Einwahl folgendes.
>
> einwahl mit vorwahl 0911.....
>
> lt Log
>
> Feb 13 13:45:03 PDC kernel: isdn_tty: call from 00911430893 -> 27 ignored
> Feb 13 13:45:03 PDC isdnlog: Feb 13 13:45:03 Call to tei 127 from +91 1430893, Indien, on +49 30/27, Berlin HANGUP (Timeout)
> Feb 13 13:45:03 PDC isdnlog: Feb 13 13:45:03 * Call to tei 127 from +91 1430893, Indien, on +49 30/27, Berlin RING (Data)
> Feb 13 13:45:07 PDC kernel: isdn_tty: call from 00911430893 -> 27 ignored

Zuwenig log, interessant ist nicht isdn_tty sondern isdn_net, bei isdn_tty
kommt immer ignored bei diesem Setup.

>
> ich habe 2 ippp?s angelegt
> ippp0 hört auf MSN 27 und hat keine Rufnummernliste da ich keine Rufnummernübermittlung habe.
> ippp1 hört auf MSN 28 und hat die die rufnummer siehe oben "00911430893" drin.
>

Wie sieht eine Anwahl von 28 aus ?

> aber keiner von uns beiden kann sich einwählen erhalten beide diese Meldung, kann es doch die Telefonanlage sein ??
Nein.

> wo kann ich noch etwas einstellen um die Einwahl zum laufen zu bekommen.

Sind die interfaces ueberhaupt hochgefahren (ifup ippp0;ifup ippp1) ?
Was sagt isdnctrl list all ?

--
Karsten Keil
SuSE Labs
ISDN development

--
Um die Liste abzubestellen, schicken Sie eine Mail an:
suse-isdn-unsubscribe@xxxxxxxx
Um eine Liste aller verfügbaren Kommandos zu bekommen, schicken
Sie eine Mail an: suse-isdn-help@xxxxxxxx


-- 
Thomas Harms
Senior Technical Consultant
ADA Das SystemHaus GmbH
Berlin
Mobil 0172/2062121



< Previous Next >
Follow Ups