On Wed, Jul 16, 2003 at 09:52:57PM +0200, Lars Wolff wrote:
N'Abend Karsten!
pnpdump >/etc/isapnp.conf
estephania:/etc # capiinit stop estephania:/etc # pnpdump >/etc/isapnp.conf
nicht machen das ueberschreibt die Datei.
estephania:/etc # capiinit stop estephania:/etc # isapnp isapnp.conf Board 1 has Identity c6 ff ff ff ff 00 09 cd 06: AVM0900 Serial No -1 [checksum c6] estephania:/etc # capiinit start Warning: loading /lib/modules/2.4.20-4GB/misc/fcpnp.o will taint the kernel: non-GPL license - Proprietary See http://www.tux.org/lkml/#export-tainted for information about tainted modules /lib/modules/2.4.20-4GB/misc/fcpnp.o: init_module: Input/output error Hint: insmod errors can be caused by incorrect module parameters, including invalid IO or IRQ parameters. You may find more information in syslog or the output from dmesg /lib/modules/2.4.20-4GB/misc/fcpnp.o: insmod /lib/modules/2.4.20-4GB/misc/fcpnp.o failed /lib/modules/2.4.20-4GB/misc/fcpnp.o: insmod fcpnp failed ERROR: failed to load driver fcpnp estephania:/etc # capiinfo capi not installed - No such device or address (6)
>>>>>>>>>>>>>>>
hm... Lieber Karsten, seit den letzten 2 versuchen verstehe ich nciht mehr und verlasse mich auch Dich ;) Danke!
Was kann man tun? die io und der irq sind doch in ordnung, oder? Hat es evtl. etwas mit rdisdn zu tun? Aber ich habe es auch probiert wenn das nicht geladen war.
Nein das ist so schon OK, nur scheint das Mainboard den IRQ nicht zur Karte zu routen. Probier mal 7 einzutragen so wie hier: # (DEBUG) (READPORT 0x0273) (ISOLATE PRESERVE) (IDENTIFY *) (VERBOSITY 2) (CONFLICT (IO FATAL)(IRQ FATAL)(DMA FATAL)(MEM FATAL)) # or WARNING (CONFIGURE AVM0900/-1 (LD 0 # Logical device decodes 16 bit IO address lines # Minimum IO base address 0x0200 # Maximum IO base address 0xffe0 # IO base alignment 32 bytes # Number of IO addresses required: 32 (IO 0 (SIZE 32) (BASE 0x0220) (CHECK)) # IRQ 3, 4, 5, 6, 7, 9, 10, 11, 12 or 15. # High true, edge sensitive interrupt (INT 0 (IRQ 7 (MODE +E))) (NAME "AVM0900/-1[0]{AVM ISDN-Controller FRITZ!Card}") (ACT Y) )) # End tag... Checksum 0x00 (OK) # Returns all cards to the "Wait for Key" state (WAITFORKEY) Naechste Idee: boote mal mit dem parameter noacpi -- Karsten Keil SuSE Labs ISDN development