Hi! Ich habe mal mit nacpi gebootet und dann nachdem ich mit pnpdump geguggt hab die werte in isapnp.conf abgeändert: (CONFIGURE AVM0900/-1 (LD 0 # Logical device decodes 16 bit IO address lines # Minimum IO base address 0x0200 # Maximum IO base address 0xffe0 # IO base alignment 32 bytes # Number of IO addresses required: 32 (IO 0 (SIZE 32) (BASE 0x0200) (CHECK)) # IRQ 3, 4, 5, 6, 7, 9, 10, 11, 12 or 15. # High true, edge sensitive interrupt (INT 0 (IRQ 3 (MODE +E))) (NAME "AVM0900/-1[0]{AVM ISDN-Controller FRITZ!Card}") # (ACT Y) )) # End tag... Checksum 0x00 (OK) # Returns all cards to the "Wait for Key" state (WAITFORKEY) "isapnp.conf" 56L, 2006C written /etc # capiinit stop /etc # isapnp isapnp.conf Board 1 has Identity c6 ff ff ff ff 00 09 cd 06: AVM0900 Serial No -1 [checksum c6] isapnp.conf:46 -- Fatal - IO range check attempted while device activated isapnp.conf:46 -- Fatal - Error occurred executing request '<IORESCHECK> ' --- further action aborted /etc # capiinit start Warning: loading /lib/modules/2.4.20-4GB/misc/fcpnp.o will taint the kernel: non-GPL license - Proprietary See http://www.tux.org/lkml/#export-tainted for information about tainted modules Module fcpnp loaded, with warnings /etc # Bringt uns das nun weiter? Was macht der Bootparameter noacpi? Ist das dass PowerManagement das ausgeschaltet wird? Lars