Hello, can any tell me why, or is this is a Problem with YaST2. I create with discpart a GPT Table and install Linux in UEFI Mode and run in Problems, on second start the UEFI code is not correct written to the NVRAM? The System is not booting? When I check the disk after Installing, the GPT Table do not exist in diskpart anymore? Next installation written a new GPT Table with YasT2 The NVRAM is cleared with efibootmgr, afterward I have also a bad UEFI Entry in the NVRAM I have only 1 Entry (0000) but the boot Order is 0001,0001,0001,0000 Sometimes after NEW Installation the UEFI Boot is possible, but it is not longer possible to Start a other System or from DVD F10 (Startmenü) and F2 (Bios Setup) is not longer working. When I clear the NVRAM with efibootmgr F10 / F2 is working again? -- mit freundlichen Grüßen / best Regards, Günther J. Niederwimmer -- To unsubscribe, e-mail: opensuse-factory+unsubscribe@opensuse.org To contact the owner, e-mail: opensuse-factory+owner@opensuse.org