Mailinglist Archive: opensuse-factory (517 mails)

< Previous Next >
Re: [opensuse-factory] No Wifi after RC2 install
  • From: "A. den Oudsten" <AdenOudsten@xxxxxx>
  • Date: Sun, 11 Jul 2010 14:31:01 +0200
  • Message-id: <4C39B985.2090803@xxxxxx>
Op 09-07-10 14:44, Larry Finger schreef:
On 07/09/2010 05:26 AM, A. den Oudsten wrote:
Dmesg

[ 14.060501] ath5k phy0: Atheros AR2425 chip found (MAC: 0xe2, PHY:
0x70)
[ 39.849914] ADDRCONF(NETDEV_UP): eth0: link is not ready

[ 90.783406] ADDRCONF(NETDEV_UP): wlan0: link is not ready


lspci -nnk

05:00.0 Ethernet controller [0200]: Broadcom Corporation NetLink
BCM5906M Fast Ethernet PCI Express [14e4:1713] (rev 02)

Subsystem: Acer Incorporated [ALI] Device [1025:0136]

Kernel driver in use: tg3

06:00.0 Ethernet controller [0200]: Atheros Communications Inc. AR5001
Wireless Network Adapter [168c:001c] (rev 01)

Subsystem: AMBIT Microsystem Corp. AR5BXB63 802.11bg NIC [1468:0428]

Kernel driver in use: ath5k

To help with the solution of this problem, please go to
http://www.linux-tips-and-tricks.de/index.php/ and download the script
named collectNMData.sh. Disconnect the wire to your Ethernet
connection, then run the script. The output should help you discover
the problem. AFAIK, the version of ath5k in RC2 is OK. I don't have
such a device, but I have not seen a lot of complaints.

Larry
It's easier to configure with KNetworkmanager was the advise. Doing so I
see:
AR5001 Wireless Network Adapter
App name: wlan0
Automatic start at startup
IP address with DHCP

Dynamic IP address DHCP both versions 4 and 6
ESSID: SpeedTouch......
verification modus WPA-PSK (WPA version 1 or 2)
Key input type
Passwordway
Encryption code ..........

Any Hints?
André
--
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx

< Previous Next >