Mailinglist Archive: opensuse-factory (517 mails)
| < Previous | Next > |
Re: [opensuse-factory] No Wifi after RC2 install
- From: Larry Finger <Larry.Finger@xxxxxxxxxxxx>
- Date: Fri, 09 Jul 2010 07:44:19 -0500
- Message-id: <4C3719A3.9080704@xxxxxxxxxxxx>
On 07/09/2010 05:26 AM, A. den Oudsten wrote:
To help with the solution of this problem, please go to
http://www.linux-tips-and-tricks.de/index.php/ and download the script named collectNMData.sh. Disconnect the wire to your Ethernet connection, then run the script. The output should help you discover the problem. AFAIK, the version of ath5k in RC2 is OK. I don't have such a device, but I have not seen a lot of complaints.
Larry
--
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx
Dmesg
[ 14.060501] ath5k phy0: Atheros AR2425 chip found (MAC: 0xe2, PHY: 0x70)
[ 39.849914] ADDRCONF(NETDEV_UP): eth0: link is not ready
[ 90.783406] ADDRCONF(NETDEV_UP): wlan0: link is not ready
lspci -nnk
05:00.0 Ethernet controller [0200]: Broadcom Corporation NetLink
BCM5906M Fast Ethernet PCI Express [14e4:1713] (rev 02)
Subsystem: Acer Incorporated [ALI] Device [1025:0136]
Kernel driver in use: tg3
06:00.0 Ethernet controller [0200]: Atheros Communications Inc. AR5001
Wireless Network Adapter [168c:001c] (rev 01)
Subsystem: AMBIT Microsystem Corp. AR5BXB63 802.11bg NIC [1468:0428]
Kernel driver in use: ath5k
To help with the solution of this problem, please go to
http://www.linux-tips-and-tricks.de/index.php/ and download the script named collectNMData.sh. Disconnect the wire to your Ethernet connection, then run the script. The output should help you discover the problem. AFAIK, the version of ath5k in RC2 is OK. I don't have such a device, but I have not seen a lot of complaints.
Larry
--
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx
| < Previous | Next > |