Mailinglist Archive: opensuse-factory (507 mails)
| < Previous | Next > |
Re: [opensuse-factory] Dual display does not work in milestone 3
- From: Jogchum Reitsma <j.reitsma@xxxxxxxxx>
- Date: Wed, 01 Jul 2009 20:10:44 +0200
- Message-id: <4A4BA6A4.9000404@xxxxxxxxx>
Daniele schreef:
both. Anyhow, I removed (well, renamd...) this nvidia_drv.so, but that
made no difference. So I went one step further, and renamed nv_drv.so
too. (nvidia_drv.so is a link to nv_drv.so, as you probably know). This
time I didn't get a "no signal", but a cursor in the left upper corner.
And Xorg.0.log complains about not being able to load nv_drv.so, and
ends with a "No screens found". Where Xorg.0.log doesn't complain at all
when nv_drv.so is present.
Should I file another bug?
regards, Jogchum
--
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx
Il mercoledì 01 luglio 2009, Jogchum Reitsma scrisse:Hm, as he worded it, I would say he meant either one of the two, not
Daniele schreef:The first is needed too!
Il martedì 30 giugno 2009, Jogchum Reitsma scrisse:Doesn't seem quite the same, though it looks that way at first sight.
Hi,Not sure but sounds like:
I installed milestone 3 yesterday on a system with two displays.
During installation, both displays showed the same screen - which
is as one would expect.
But when, at the end of the installation cyclus, the system boots
up, I get a 'no signal' on both displays when entering runlevel 5.
Rebooting does not help. I can go to console 1, which gives me 1
display.
OpenSuse 11.1 handles dual display OK.
System is MSI Master 2FAR, two dualcore Opterons, 2GB memory.
NVidia GForce 6200.
Displays are Iiyama Vision Master Pro 450 and --- 512.
Bug, or not yet implemented in this milestone, ore somthing else?
http://bugzilla.novell.com/show_bug.cgi?id=517102
Bye.
But the second advice of Stephan Dirsch is already applied in my
case. Below my x.org:
Remove the fake nvidia driver and try again..
Bye.
both. Anyhow, I removed (well, renamd...) this nvidia_drv.so, but that
made no difference. So I went one step further, and renamed nv_drv.so
too. (nvidia_drv.so is a link to nv_drv.so, as you probably know). This
time I didn't get a "no signal", but a cursor in the left upper corner.
And Xorg.0.log complains about not being able to load nv_drv.so, and
ends with a "No screens found". Where Xorg.0.log doesn't complain at all
when nv_drv.so is present.
Should I file another bug?
regards, Jogchum
--
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx
| < Previous | Next > |