Mailinglist Archive: opensuse-factory (277 mails)
| < Previous | Next > |
Re: [opensuse-factory] Difference in install behaviour, bug, or intended?
- From: Oddball <monkey9@xxxxxx>
- Date: Mon, 30 Mar 2009 21:27:14 +0200
- Message-id: <49D11D12.1000007@xxxxxx>
Rajko M. schreef:
I did a 11.2 net.iso install this afternoon, came to the hardware
configuration, and then the graphicscard config failed: Black screen.
Might be wrong kernel? I don't know.
Today, i quit.
Tomorrow is another day.
Thnx for involvement.
--
Enjoy your time around,
Oddball, aka M9.
OS: Linux 2.6.27.19-3.2-default x86_64
Huidige gebruiker: oddball@AMD64x2-sfn1
Systeem: openSUSE 11.1 (x86_64)
KDE: 4.2.1 (KDE 4.2.1) "release 103"
--
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx
I have to try the way you suggest.
Possibilities:
1) Installer picks up someting from other installation, which it should not
do. This is not very big chance to happen, but not excluded.
2) Wireless firmware setup requires clean wireless chip without any firmware
loaded. This seems to me closer guess where to start troubleshooting. Driver
for chip can assume that chip has not firmware, while it actually has because
of present battery in laptops, and mess whole thing.
I would try first to remove anything with wireless in the name from
installation that has a problem with wireless. Then, turn eee-pc off,
disconnect power cord, and pull battery out. Leave it for few minutes to make
sure that all hardware registers are cleared (capacitors in power supply
chain discharged). Then turn on, boot to partition that has a problem, try to
setup wireless again.
If this fails, then step two would be new installation, but after formatting
partitions go trough turn eee-pc off, disconnect power cord, and pull battery
out, leave it for few minutes drill, before attempt to install again.
If that fails then some of openSUSE wireless hardware experts should jump in.
If it works, then check the other installation, does it work after normal
reboot, and then after cold reboot with pulling battery out.
I did a 11.2 net.iso install this afternoon, came to the hardware
configuration, and then the graphicscard config failed: Black screen.
Might be wrong kernel? I don't know.
Today, i quit.
Tomorrow is another day.
Thnx for involvement.
--
Enjoy your time around,
Oddball, aka M9.
OS: Linux 2.6.27.19-3.2-default x86_64
Huidige gebruiker: oddball@AMD64x2-sfn1
Systeem: openSUSE 11.1 (x86_64)
KDE: 4.2.1 (KDE 4.2.1) "release 103"
--
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx
| < Previous | Next > |