Mailinglist Archive: opensuse-factory (845 mails)
| < Previous | Next > |
[opensuse-factory] Opensuse 11 Beta 2 fails to install
- From: "Juan Erbes" <jerbes@xxxxxxxxx>
- Date: Tue, 13 May 2008 08:42:15 -0300
- Message-id: <61ec494a0805130442m68fa0dc0g7a11fac8b50e6211@xxxxxxxxxxxxxx>
I'm using in my computer Opensuse 10.3, 64 and 32 bits without
problems, and yesterday I would to upgrade the 64 bits partition to
Opensuse 11 Beta 2, and it fails to detect the SATA hard disk because
the ahci driver do'nt loads right.
In Opensuse 10.3 the bios is set to "IDE Native", and it was the same
if the bios is set to AHCI, but because for other OS compatibility, I
must set it to "IDE Native".
I do'nt remember the parameter that I used for installing 10.3 at boot
time for the install. I mean it was "pci=nomsi", and the chipset is
ATI SB600. For Opensuse 11 Beta 2, I must use the same parameter?
Thanks
---------------------------------------------------------------------
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx
problems, and yesterday I would to upgrade the 64 bits partition to
Opensuse 11 Beta 2, and it fails to detect the SATA hard disk because
the ahci driver do'nt loads right.
In Opensuse 10.3 the bios is set to "IDE Native", and it was the same
if the bios is set to AHCI, but because for other OS compatibility, I
must set it to "IDE Native".
I do'nt remember the parameter that I used for installing 10.3 at boot
time for the install. I mean it was "pci=nomsi", and the chipset is
ATI SB600. For Opensuse 11 Beta 2, I must use the same parameter?
Thanks
---------------------------------------------------------------------
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx
| < Previous | Next > |