Mailinglist Archive: opensuse-factory (626 mails)

["Rajko M." <rmatov101@xxxxxxxxxxx>]

Partitioning proposal to use 10.3 disk was rejected and I was in Expert 
Partitioner. Deleted partitions on HD1 and HD2 and started to create new. 

Selected (highlighted) hard disk that I want to work on. 
Press Create button and partitioner is asking me what disk to use. 
It would be nice to inform module, that is behind Create button, that hard 
disk is already selected. 

After being done with HD1, I selected HD2 and pressed Create button. 
Why when I knew that preselection doesn't have effect. Probably because it is 
that way in many other programs, select object that you want to work on and 
start action. It works automatically. 

The dialog to select hard disk popped up and I can select either disk, 
although HD1 is completely used. I can't recall what disk was marked when 
dialog was opened, but it should be the last that I worked on, so it would be 
HD1. 

Press OK and I can see the message that there is no space on disk. 

It would be better to put check, is there room on HD, before you open dialog 
asking on which disk to work. In this case it would be possible to completely 
skip dialog, as there was only one disk left. In other cases one can remove 
disks that are full from the list. 

-- 
Regards, Rajko.
See http://en.opensuse.org/Portal
---------------------------------------------------------------------
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx