Mailinglist Archive: opensuse-factory (509 mails)

[Carlos F Lange <carlos.lange@xxxxxxxxxxx>]

On Sun August 19 2007 06:01, Juan Erbes wrote:
> You use the propietary drivers?
>
> In my case, sax2 do'nt work right with the propietary drivers of my
> video card. I I use "sax2 -r -m 0=fglrx" (after configured via
> aticonfig), later in kde I got a black screen in kde. I must leave so
> as configured by aticonfig, and the works right.

My X60 has an Intel graphic card, as I say below, and the driver is the 
open source "intel". The same driver (I don't know how to check its 
version) is used by 10.1 and gives good 3D results.

> 2007/8/18, Carlos F Lange <carlos.lange@xxxxxxxxxxx>:
> > Hi,
> >
> > My installation of 10.3 beta 1 on Thinkpad X60 went well.
> > [...]
> > Beside these minor issues, the main issue is with graphics.
> > The graphics card is Intel 945 GM. I did not activate 3D
> > acceleration right away and I got 720 FPM from glxgears at first.
> >
> > After activating 3D acceleration through in SaX2, the rate improved
> > to only 840 FPM only. In 10.1 I can get 1200 FPM with glxgears on
> > the same hardware. So, 3D acceleration is not working properly in
> > 10.3b1 for this card.


-- 
Carlos FL

Who is General Failure, and why is he reading my disk?
---------------------------------------------------------------------
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx