Mailinglist Archive: opensuse-factory (1165 mails)

[Markus Koßmann <markus.kossmann@xxxxxxxxxxxxxx>]

Today I got a new pc with ASUS M2NPV-MX motherboard.CDROM is HL-DT-ST DVD-RAM 
GSA-H10N. 
Installation from RC1 x86_64  CD set works fine ( including media check for 
all CDs) until first media change.
When the messagebox asking for CD2  pops up , the dvd drive is still locked.  
You need to click the eject button.
Then you will the messages on console 4: 

hda: irq timeout: status=0x10d { busy } 
ide: failed opcode was: unkown
hda: DMA disabled
hda: ATAPI reset complete

If you try to access the 2nd CD after the reset, by clicking OK in the message 
boy, you will see now:
  
attempt to  access beyond end of device
hda: rw=0, want=1419404, limit=1335712
Buffer I/O error on device /dev/hda, logical block 354850

If I switch to a console and run md5sum on the 2nd CD I get a wrong checksum  
But if I put the CD into another PC the checksum is OK again. 
When running md5sum on CD1 on the new PC  all is OK
Then I burned another CD2 on the other PC , verified  it  before inserting 
with md5sum  and the exact same  buffer error occurs again. 
and running md5sum on the new PC  gives exact the same wrong value as before. 
with the other media. back in the other PC checksum id OK again.
And if reboot on the new PC  from installation into the rescue system and run 
md5sum  on CD2 it  is OK again.   
Changing the DVD drive to another model and moving it from primary IDE to 
secondary IDE doesn't change anything
Also using the pata_nv driver instead of amd74xx only changes the error 
message, but the drive will also be  resetted and fails to work after that. 

Are the any known issues with NVIDIA 6150 based board relating to the IDE 
controler, or is this just a defective board ? 





 
---------------------------------------------------------------------
To unsubscribe, e-mail: opensuse-factory+unsubscribe@xxxxxxxxxxxx
For additional commands, e-mail: opensuse-factory+help@xxxxxxxxxxxx