Hallo Leute, Am Montag, 20. Februar 2006 17:40 schrieb David Barker:
On 2/19/06, James PEARSON
wrote: I have a strange problem when installing beta4 into VMware 4.5.2: CD1 and CD2 are installed without problems, but CD3 is not recognized - YaST keeps asking for it. [...] I had the same problem except that I am using the latest Vmware v5.5 (VMware-workstation-5.5.1-19175).
My main question is still open - is this a known bug or should I report it?
The install process blocked when I gave it the 3rd CD. After hiting ENTER a couple of times, I finally chose "Ignore" and voila, I had the same problem for the 4th CD. I chose "Ignore" again and the install process asked for the 5th CD. The 5th CD ran without any problems and the installation continued up
I didn't need CD 4 and 5 - but that sounds like a funny effect.
until "Hardware Configuration" page setup where there is still a problem on the "Hardware Configuration" setup page.
You mean the box says "system analyses" forever? (translated back from german, but you should get the point) I just skipped it and didn't notice problems yet ;-)
I believe that is last problem is related to Sax2 configuration process under Vmware.
I was able to chose eject and then ok to continue with the install however sax2 can't configure the xserver even after installing the vmware tools.
Try sax2 -m 0=vesa as workaround (found in Bug 148211) - this worked for me (IIRC only after a "init 6") Regards, Christian Boltz --
Es steht dir frei, dich auch auszutragen, damit du von Idioten wie David, Thorsten, Bernd, ... nicht weiter belästigt wirst. Und ich gehöre da nicht mehr dazu? [> Matthias Houdek und Florian Gross in suse-linux]