Dear All, I'm trying to install Smoothwall-0.9.8 onto an IBM P166 that I bought from Morgan Computers. I'm using a D-Link DFE530-TX card that uses a VIA-Rhine driver and a PCI slot but I'm having no joy getting the card to install on the box. The mainboard is a 'Personal Computer 300GL System Board'. I use a boot.img floppy that comes with Smoothwall and the opening screen brings up a boot: _ prompt and offers me the chance of entering kernel parameters or just pressing RETURN. Should I be typing in something at this point? I get successfully through partitioning the hard disk but fall over at the first hurdle on the 'configure networking' stage. The screen starts off by telling me: 'You should now configure networking by first loading the correct driver for the GREEN interface.' This throws me a bit. Does this mean that it really hasn't detected anything? Autoprobing fails and when I choose the 'VIA Rhine PCI Fast Ethernet, etc' option from the list of drivers it immediately flashes back 'Error: Unable to load driver module'. The machine came with a network card already in an ISA slot and the diagram of the System Board shows an onboard 'Integrated Ethernet Controller' when I gave this a try at least its LEDs flashed. At no time during the power on and boot up do the LEDs on the PCI netwlrk card flash. Does this mean that the PCI slots are somehow disabled? In the machine's 'Configuration / Setup Utilty' under 'Advanced Setup' there is scope to toggle options to do with PCI Control. Changes here don't alter what happens at all. Has anyone any advice?