Mailinglist Archive: opensuse-de (1905 mails)
| < Previous | Next > |
Re: NetworkManager
- From: Kai Grunau <kgrunau@xxxxxxxxxxxxx>
- Date: Wed, 23 Jan 2008 09:26:35 +0100
- Message-id: <4796FA3B.6030804@xxxxxxxxxxxxx>
Hallo,
Jan Ritzerfeld wrote:
22: PCI 300.0: 0282 WLAN controller
[Created at pci.301]
UDI: /org/freedesktop/Hal/devices/pci_8086_4227
Unique ID: JNkJ.mAONicWAIr5
Parent ID: qTvu._Y5kuEY+GiC
SysFS ID: /devices/pci0000:00/0000:00:1c.1/0000:03:00.0
SysFS BusID: 0000:03:00.0
Hardware Class: network
Model: "Intel Thinkpad X60s, R60e model 0657"
Vendor: pci 0x8086 "Intel Corporation"
Device: pci 0x4227 "PRO/Wireless 3945ABG Network Connection"
SubVendor: pci 0x8086 "Intel Corporation"
SubDevice: pci 0x1011 "Thinkpad X60s, R60e model 0657"
Revision: 0x02
Driver: "ipw3945"
Driver Modules: "ipw3945"
Device File: eth1
Features: WLAN
Memory Range: 0xdf6ff000-0xdf6fffff (rw,non-prefetchable)
IRQ: 17 (no events)
HW Address: 00:1c:bf:3d:22:8a
Link detected: no
WLAN channels: 1 2 3 4 5 6 7 8 9 10 11 12 13 34 36 38 40 42 44 46 48 52 56 60 64 100 104 108 112 116 120 124
WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457 2.462 2.467 2.472 5.17 5.18 5.19 5.2 5.21 5.22 5.23 5.24 5.26 5.28 5.3 5.32 5.5 5.52 5.54 5.56 5.58 5.6 5.62
WLAN bitrates: 1 2 5.5 11 6 9 12 18 24 36 48 54
WLAN encryption modes: WEP40 WEP104 TKIP CCMP
WLAN authentication modes: open sharedkey wpa-psk wpa-eap
Module Alias: "pci:v00008086d00004227sv00008086sd00001011bc02sc80i00"
Driver Info #0:
Driver Status: iwl3945 is not active
Driver Activation Cmd: "modprobe iwl3945"
Driver Info #1:
Driver Status: ipw3945 is active
Driver Activation Cmd: "modprobe ipw3945"
Config Status: cfg=no, avail=yes, need=no, active=unknown
Attached to: #9 (PCI bridge)
--------------------
Wenn ich den Laptop starte und das eth0 device (wired network) angeschlossen ist,
habe ich nach dem login eine Netzwerverbindung.
Man kann dann ueber den KNetworkManager ein "Connect to Other Wireless Network" starten,
die ESSID eingeben und das eth0 device wird deaktiviert und das eth1 kann sich mit dem AccessPoint verbinden ! Toll
Breche ich die wireless Verbindung ab startet der NetWorker wieder die eth0 Verbindung ! Tolltoll
Jeder weitere Versuch nocheinmal die Wireless Verbindung zu aktivieren scheitert :-(
/var/log/NetworkManager
---------
NetworkManager: <debug> [1201076162.332217] nm_device_802_11_wireless_get_activation_ap(): Forcing AP ' XXXXXXX'
User Switch: /org/freedesktop/NetworkManager/Devices/eth1 / XXXXXX
Deactivating device eth1.
NetworkManager: <info> Device eth1 activation scheduled...
NetworkManager: <info> Deactivating device eth0.
NetworkManager: <info> Activation (eth1) started...
NetworkManager: <info> Activation (eth1) Stage 1 of 5 (Device Prepare) scheduled...
NetworkManager: <info> Activation (eth1) Stage 1 of 5 (Device Prepare) started...
NetworkManager: <info> Activation (eth1) Stage 2 of 5 (Device Configure) scheduled...
NetworkManager: <info> Activation (eth1) Stage 1 of 5 (Device Prepare) complete.
NetworkManager: <info> Activation (eth1) Stage 2 of 5 (Device Configure) starting...
NetworkManager: <info> Activation (eth1/wireless): access point 'XXXXXX' is unencrypted, no key needed.
NetworkManager: <info> SUP: sending command 'INTERFACE_ADD eth1 wext /var/run/wpa_supplicant '
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> SUP: sending command 'AP_SCAN 1'
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> SUP: sending command 'ADD_NETWORK'
NetworkManager: <info> SUP: response was '0'
NetworkManager:<info> SUP: sending command 'SET_NETWORK 0 ssid 69666d2d67656f6d61722d6775657374'
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> SUP: sending command 'SET_NETWORK 0 scan_ssid 1'
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> SUP: sending command 'SET_NETWORK 0 key_mgmt NONE'
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> SUP: sending command 'ENABLE_NETWORK 0'
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> Activation (eth1) Stage 2 of 5 (Device Configure) complete.
NetworkManager: <info> Activation (eth1/wireless): association took too long (>60s), failing activation.
NetworkManager: <info> Activation (eth1) failure scheduled...
NetworkManager: <info> Activation (eth1) failed for access point (ifm-geomar-guest)
NetworkManager: <info> Activation (eth1) failed.
NetworkManager: <info> Deactivating device eth1.
NetworkManager: <info> SWITCH: no current connection, found better connection 'eth0'.
NetworkManager: <info> Will activate connection 'eth0'.
-----------------------------
So sieht es aus ..............
Gruss , Kai
--
Um die Liste abzubestellen, schicken Sie eine Mail an:
opensuse-de+unsubscribe@xxxxxxxxxxxx
Um eine Liste aller verfuegbaren Kommandos zu bekommen, schicken
Sie eine Mail an: opensuse-de+help@xxxxxxxxxxxx
Jan Ritzerfeld wrote:
Naja, der Bug ist scheinbar eben nicht gefixt, ich würde das dann mal in einem Kommentar den Entwicklern mitteilen!wen muss man "anmailen" ?
BTW, du schreibst, daß du den ipw3945-Treiber benutzen würdest. Bist du dir da sicher? Oder ist das nur ein Tippfehler? Was sagt "hwinfo --wlan"?work:> hwinfo --wlan
22: PCI 300.0: 0282 WLAN controller
[Created at pci.301]
UDI: /org/freedesktop/Hal/devices/pci_8086_4227
Unique ID: JNkJ.mAONicWAIr5
Parent ID: qTvu._Y5kuEY+GiC
SysFS ID: /devices/pci0000:00/0000:00:1c.1/0000:03:00.0
SysFS BusID: 0000:03:00.0
Hardware Class: network
Model: "Intel Thinkpad X60s, R60e model 0657"
Vendor: pci 0x8086 "Intel Corporation"
Device: pci 0x4227 "PRO/Wireless 3945ABG Network Connection"
SubVendor: pci 0x8086 "Intel Corporation"
SubDevice: pci 0x1011 "Thinkpad X60s, R60e model 0657"
Revision: 0x02
Driver: "ipw3945"
Driver Modules: "ipw3945"
Device File: eth1
Features: WLAN
Memory Range: 0xdf6ff000-0xdf6fffff (rw,non-prefetchable)
IRQ: 17 (no events)
HW Address: 00:1c:bf:3d:22:8a
Link detected: no
WLAN channels: 1 2 3 4 5 6 7 8 9 10 11 12 13 34 36 38 40 42 44 46 48 52 56 60 64 100 104 108 112 116 120 124
WLAN frequencies: 2.412 2.417 2.422 2.427 2.432 2.437 2.442 2.447 2.452 2.457 2.462 2.467 2.472 5.17 5.18 5.19 5.2 5.21 5.22 5.23 5.24 5.26 5.28 5.3 5.32 5.5 5.52 5.54 5.56 5.58 5.6 5.62
WLAN bitrates: 1 2 5.5 11 6 9 12 18 24 36 48 54
WLAN encryption modes: WEP40 WEP104 TKIP CCMP
WLAN authentication modes: open sharedkey wpa-psk wpa-eap
Module Alias: "pci:v00008086d00004227sv00008086sd00001011bc02sc80i00"
Driver Info #0:
Driver Status: iwl3945 is not active
Driver Activation Cmd: "modprobe iwl3945"
Driver Info #1:
Driver Status: ipw3945 is active
Driver Activation Cmd: "modprobe ipw3945"
Config Status: cfg=no, avail=yes, need=no, active=unknown
Attached to: #9 (PCI bridge)
--------------------
Wenn ich den Laptop starte und das eth0 device (wired network) angeschlossen ist,
habe ich nach dem login eine Netzwerverbindung.
Man kann dann ueber den KNetworkManager ein "Connect to Other Wireless Network" starten,
die ESSID eingeben und das eth0 device wird deaktiviert und das eth1 kann sich mit dem AccessPoint verbinden ! Toll
Breche ich die wireless Verbindung ab startet der NetWorker wieder die eth0 Verbindung ! Tolltoll
Jeder weitere Versuch nocheinmal die Wireless Verbindung zu aktivieren scheitert :-(
/var/log/NetworkManager
---------
NetworkManager: <debug> [1201076162.332217] nm_device_802_11_wireless_get_activation_ap(): Forcing AP ' XXXXXXX'
User Switch: /org/freedesktop/NetworkManager/Devices/eth1 / XXXXXX
Deactivating device eth1.
NetworkManager: <info> Device eth1 activation scheduled...
NetworkManager: <info> Deactivating device eth0.
NetworkManager: <info> Activation (eth1) started...
NetworkManager: <info> Activation (eth1) Stage 1 of 5 (Device Prepare) scheduled...
NetworkManager: <info> Activation (eth1) Stage 1 of 5 (Device Prepare) started...
NetworkManager: <info> Activation (eth1) Stage 2 of 5 (Device Configure) scheduled...
NetworkManager: <info> Activation (eth1) Stage 1 of 5 (Device Prepare) complete.
NetworkManager: <info> Activation (eth1) Stage 2 of 5 (Device Configure) starting...
NetworkManager: <info> Activation (eth1/wireless): access point 'XXXXXX' is unencrypted, no key needed.
NetworkManager: <info> SUP: sending command 'INTERFACE_ADD eth1 wext /var/run/wpa_supplicant '
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> SUP: sending command 'AP_SCAN 1'
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> SUP: sending command 'ADD_NETWORK'
NetworkManager: <info> SUP: response was '0'
NetworkManager:<info> SUP: sending command 'SET_NETWORK 0 ssid 69666d2d67656f6d61722d6775657374'
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> SUP: sending command 'SET_NETWORK 0 scan_ssid 1'
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> SUP: sending command 'SET_NETWORK 0 key_mgmt NONE'
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> SUP: sending command 'ENABLE_NETWORK 0'
NetworkManager: <info> SUP: response was 'OK'
NetworkManager: <info> Activation (eth1) Stage 2 of 5 (Device Configure) complete.
NetworkManager: <info> Activation (eth1/wireless): association took too long (>60s), failing activation.
NetworkManager: <info> Activation (eth1) failure scheduled...
NetworkManager: <info> Activation (eth1) failed for access point (ifm-geomar-guest)
NetworkManager: <info> Activation (eth1) failed.
NetworkManager: <info> Deactivating device eth1.
NetworkManager: <info> SWITCH: no current connection, found better connection 'eth0'.
NetworkManager: <info> Will activate connection 'eth0'.
-----------------------------
So sieht es aus ..............
Gruss , Kai
--
Um die Liste abzubestellen, schicken Sie eine Mail an:
opensuse-de+unsubscribe@xxxxxxxxxxxx
Um eine Liste aller verfuegbaren Kommandos zu bekommen, schicken
Sie eine Mail an: opensuse-de+help@xxxxxxxxxxxx
| < Previous | Next > |