Hallo, ich habe hier gerade Mainboard getauscht (von ASUS auf MSI, beides NForce-Chipsatz), aber leider funktioniert USB-Hotplug (immer noch) nicht. Das neue Board ist ein K7N2 Delta-L, wobei sich die Probleme vom alten auf's neue Board kaum verändert haben, außer daß ich jetzt als Boot-Option ACPI=OFF angeben muß, damit er mir nicht bei "Starting Hotplugging Services" stehen bleibt (wahrscheinlich war aber ACPI beim Asus-Board schon im BIOS deaktiviert). Naja.. jedenfalls krieg ich wenn ich denn einen USB-Stick anschließe folgende Meldungen im /var/log/messages: Oct 28 10:12:47 workstation kernel: hub.c: new USB device 00:02.2-2, assigned address 10 Oct 28 10:12:47 workstation kernel: scsi0 : SCSI emulation for USB Mass Storage devices Oct 28 10:12:47 workstation kernel: Vendor: Generic Model: USB Flash Disk Rev: 2.00 Oct 28 10:12:47 workstation kernel: Type: Direct-Access ANSI SCSI revision: 02 Oct 28 10:12:47 workstation kernel: Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0 Oct 28 10:12:47 workstation kernel: sda : READ CAPACITY failed. Oct 28 10:12:47 workstation kernel: sda : status = 1, message = 00, host = 0, driver = 08 Oct 28 10:12:47 workstation kernel: Current sd00:00: sns = 70 6 Oct 28 10:12:47 workstation kernel: ASC=28 ASCQ= 0 Oct 28 10:12:47 workstation kernel: Raw sense data:0x70 0x00 0x06 0x00 0x00 0x00 0x00 0x0a 0x00 0x00 0x00 0x00 0x28 0x00 0x00 0x00 0x00 0x00 Oct 28 10:12:47 workstation kernel: sda : block size assumed to be 512 bytes, disk size 1GB. Oct 28 10:14:02 workstation kernel: sda:usb_control/bulk_msg: timeout Manchmal kommt dann auch erst noch ein paar mal: Oct 28 10:12:37 workstation kernel: hub.c: new USB device 00:02.2-2, assigned address 8 Oct 28 10:12:37 workstation kernel: usb.c: USB device not accepting new address=8 (error=-71) Oct 28 10:12:38 workstation kernel: hub.c: new USB device 00:02.2-2, assigned address 9 Oct 28 10:12:38 workstation kernel: usb.c: USB device not accepting new address=9 (error=-71) Zeitweise hat's auch schon mal funktioniert (mit dem alten Board), wenn dann aber auch nur äußerst langsam (Zeit bis zum Hotplug-Beep ca. 1 Min) und mit erschütternden Datentransferraten wo eine Floppy dagegen noch äußerst gut weg kommt. Gelegentlich gab's auch Abstürze beim Zugriff. Wäre nett, wenn mir jemand ein paar Tipps geben würde, woran sowas liegen könnte. Danke. Gruß, Dieter