Hi Leute, ich habe mir einen Cardreader (Revoltec Prokyon) gekauft, beim Anstecken sieht alles ganz gut aus. dmesg gibt aus: UDF-fs: No partition found (1) subfs: unsuccessful attempt to mount media (256) cdrom: open failed. cdrom: open failed. subfs: unsuccessful attempt to mount media (256) usb 2-1: USB disconnect, address 2 subfs: unsuccessful attempt to mount media (256) subfs: unsuccessful attempt to mount media (256) usb 4-6: new high speed USB device using address 2 usb 4-6: Product: 2.0 Card Reader usb 4-6: Manufacturer: ICSI usb 4-6: SerialNumber: 00000000001DF scsi2 : SCSI emulation for USB Mass Storage devices Vendor: ICSI Model: CF Card CF Rev: 1.3D Type: Direct-Access ANSI SCSI revision: 02 Attached scsi removable disk sdb at scsi2, channel 0, id 0, lun 0 Attached scsi generic sg1 at scsi2, channel 0, id 0, lun 0, type 0 Vendor: ICSI Model: SD Card MMC/SD Rev: 1.3D Type: Direct-Access ANSI SCSI revision: 02 Attached scsi removable disk sdc at scsi2, channel 0, id 0, lun 1 Attached scsi generic sg2 at scsi2, channel 0, id 0, lun 1, type 0 Vendor: ICSI Model: MS Card MS Rev: 1.3D Type: Direct-Access ANSI SCSI revision: 02 Attached scsi removable disk sdd at scsi2, channel 0, id 0, lun 2 Attached scsi generic sg3 at scsi2, channel 0, id 0, lun 2, type 0 Vendor: ICSI Model: SM Card SM Rev: 1.3D Type: Direct-Access ANSI SCSI revision: 02 Attached scsi removable disk sde at scsi2, channel 0, id 0, lun 3 Attached scsi generic sg4 at scsi2, channel 0, id 0, lun 3, type 0 USB Mass Storage device found at 2 Was mir sagt, dass alle Schächte erkannt wurden. Oder? Stecke ich nun einen MemoryStick ein, erscheint folgendes bei dmesg: USB Mass Storage device found at 2 scsi: Device offlined - not ready after error recovery: host 2 channel 0 id 0 lun 0 Was heißt das für mich, läuft der Cardreader nicht unter Linux oder ist er eher defekt? Lieber Gruß Can