On 22 Feb 2001, at 9:25, Richard Cochius wrote:
Es ist nur eine Festplatte im Rechner. BOOT und ROTT liegen unter 1024 Zylindern. Beim Booten über Floppy, d.h. mit MINIX formartiert und mit yast gesagt, dass LILO auf Diskette geschrieben werden soll. An meinem Notebook hat das geholfen. Bei diesem Rechner auch nur LI.
Hi, ich hab mal wieder in /usr/share/doc gesucht: ----------------8<-------------------------------- LILO start message - - - - - - - - - When LILO loads itself, it displays the word "LILO". Each letter is printed before or after performing some specific action. If LILO fails at some point, the letters printed so far can be used to identify the problem. This is described in more detail in the technical overview. Note that some hex digits may be inserted after the first "L" if a transient disk problem occurs. Unless LILO stops at that point, generating an endless stream of error codes, such hex digits do not indicate a severe problem. (<nothing>) No part of LILO has been loaded. LILO either isn't installed or the partition on which its boot sector is located isn't active. L <error> ... The first stage boot loader has been loaded and started, but it can't load the second stage boot loader. The two-digit error codes indicate the type of problem. (See also section "Disk error codes".) This condition usually indicates a media failure or a geometry mismatch (e.g. bad disk parameters, see section "Disk geometry"). LI The first stage boot loader was able to load the second stage boot loader, but has failed to execute it. This can either be caused by a geometry mismatch or by moving /boot/boot.b without running the map installer. LIL The second stage boot loader has been started, but it can't load the descriptor table from the map file. This is typically caused by a media failure or by a geometry mismatch. LIL? The second stage boot loader has been loaded at an incorrect address. This is typically caused by a subtle geometry mismatch or by moving /boot/boot.b without running the map installer. LIL- The descriptor table is corrupt. This can either be caused by a geometry mismatch or by moving /boot/map without running the map installer. LILO All parts of LILO have been successfully loaded. ----------------8<-------------------------------- Da steht jetzt beim Fehler LI, daß das was mit der Datei /boot/boot.b bzw. mit den Plattendaten zu tun haben könnte. Check mal inwieweit das alles in Ordnung ist. <VERMUTUNG> Du hast die Platte ins BIOS eingetragen. Dort hat sie allerdings nur 4GB anstatt der 8GB, die sie hat. Das ist in meinen Augen ein Fehler mit den Plattendaten. Wenn Du die Platte nicht ins BIOS einträgst und mit einer Diskette startest geht es. <\VERMUTUNG> ansonsten würd ich mir die o.a. Datei genau durchlesen. hth Alex