Hi Sascha, schau Dir doch mal die /usr/share/doc/packages/lilo/README bzw. /usr/doc/packages/lilo/README an. Da steht unter LILO start message - - - - - - - - - WhenLILO loads itself, it displays the word "LILO". Each letter is printed beforeor after performing some specific action. If LILO fails at some point,the letters printed so far can be used to identify the problem. This is described in more detail in the technical overview. Notethat some hex digits may be inserted after the first "L" if a transientdisk problem occurs. Unless LILO stops at that point, generating an endless stream of error codes, such hex digits do not indicate a severe problem. (<nothing>) No part of LILO has been loaded. LILO either isn't installed or the partition on which its boot sector is located isn't active. L <error> ... The first stage boot loader has been loaded and started, but it can't load the second stage boot loader. The two-digit error codes indicate the type of problem. (See also section "Disk error codes".) This condition usually indicates a media failure or a geometry mismatch (e.g. bad disk parameters, see section "Disk geometry"). Ich bin im Moment leider zu müde, um weiterzusuchen *gähn*. Wenn Du nicht weiterkommst schreib mir ne PM und ich schau mir das morgen noch mal an. Sayonara Alex