Mailinglist Archive: opensuse-buildservice (177 mails)

< Previous Next >
Re: [opensuse-buildservice] SLES for Raspberry Pi 3
  • From: Robert Munteanu <robert.munteanu@xxxxxxxxx>
  • Date: Wed, 14 Dec 2016 11:49:03 +0200
  • Message-id: <CAC8ULPbeLHiZGTB21M69wS4KOPgb8Ot-9A=TXo7ZhCqXdJkt=g@mail.gmail.com>
On Wed, Dec 14, 2016 at 10:18 AM, Roger Oberholtzer
<roger.oberholtzer@xxxxxxxxx> wrote:
On Wed, Dec 14, 2016 at 8:29 AM, Robert Munteanu
<robert.munteanu@xxxxxxxxx> wrote:
On Wed, Dec 14, 2016 at 8:51 AM, Roger Oberholtzer
<roger.oberholtzer@xxxxxxxxx> wrote:

What I really want to do is install openSUSE on the PI3.


Have you seen
https://en.opensuse.org/HCL:Raspberry_Pi3#Installing_the_64-bit_openSUSE_Leap_image
?

Leap works just fine on my Pi 3. I did not have time to run it through
all the tests, but I found no problems so far.

I have tried the following:

openSUSE-13.1-ARM-JeOS-raspberrypi.armv7l-1.12.1-Build38.15.raw.xz
openSUSE-Tumbleweed-ARM-JeOS-raspberrypi3_aarch64.aarch64-2016.09.06-Build6.1.raw.xz
openSUSE-Tumbleweed-ARM-JeOS-raspberrypi3_aarch64.armv7l-2016.04.06-Build2.1.raw.xz
openSUSE-Tumbleweed-ARM-JeOS-raspberrypi3.armv7l-2016.06.28-Build1.5.raw.xz
openSUSE-Tumbleweed-ARM-JeOS-raspberrypi3.armv7l-2016.08.20-Build1.4.raw.xz

And they do not even boot. What has worked is:

SLES-12-SP2-ARM-X11-raspberrypi3_aarch64.aarch64-2016.10.04-GM.raw.xz


I will try a newer openSUSE image to see if it works. Exactly which
image have you used?

I tried a Leap 42.2 image, I think it was one similar to

openSUSE-Leap42.2-ARM-JeOS-raspberrypi3.aarch64-2016.11.25-Build1.9.raw.xz

Robert




--
http://robert.muntea.nu/
--
To unsubscribe, e-mail: opensuse-buildservice+unsubscribe@xxxxxxxxxxxx
To contact the owner, e-mail: opensuse-buildservice+owner@xxxxxxxxxxxx

< Previous Next >