https://bugzilla.novell.com/show_bug.cgi?id=876184 https://bugzilla.novell.com/show_bug.cgi?id=876184#c0 Summary: Enhancement: to disable scanner menu, when install/remove software is in use Classification: openSUSE Product: openSUSE 13.1 Version: Final Platform: 64bit OS/Version: openSUSE 13.1 Status: NEW Severity: Enhancement Priority: P5 - None Component: YaST2 AssignedTo: yast2-maintainers@suse.de ReportedBy: contracts@lobikfilip.eu QAContact: jsrain@suse.com Found By: --- Blocker: --- User-Agent: Mozilla/5.0 (X11; Linux x86_64; rv:28.0) Gecko/20100101 Firefox/28.0 Due to the fact, that during the first configuration of a scanner on OpenSUSE 13.1 in YaST2, it takes a very long time until the list of supported scanners appears, and I am almost sure that it is always required to install new packages to make the first installed scanner work, I suggest that that the "Scanner" menu in "Yast2" be disabled during the installation procedure, if the "install new software" procedure is on: - user clicks on "Scanner" in "Yast2" - "Yast2" checks whether software management features are processing - if "yes", then break and notify to open after install (or suggest to open after software management will be done) - else: keep it real Reproducible: Always Steps to Reproduce: 1. Install software 2. Open "Scanner" in "Yast2" for first time configuration 3. Add new scanner Actual Results: could not install hpaio could not install hplip Expected Results: don't open scanner, if it's being run for the first time & install software is in use -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.