https://bugzilla.novell.com/show_bug.cgi?id=615761
https://bugzilla.novell.com/show_bug.cgi?id=615761#c70
--- Comment #70 from Pierre Pasche 2010-11-25 18:10:26 UTC ---
(In reply to comment #62)
I had the same problem on Dell 780 with the latest BIOS and with Intel® 82567
Gigabit Ethernet Controller, after a remote ssh install using PXE. Stage 1 of
installation was successful but when starting stage 2 (configuration), DHCP
could not initialize the eth0 interface.
ifconfig -a doesn't event show eth0 (which was used in stage 1).
A reboot after "stage 1" (i mean before stage2), make the interface eth0 back
available and DHCP could configure it correctly. And stage 2 could be run
correctly.
If you don't need the network during stage 2 (without ssh install, no
registration, no update, ...), configuration is done correctly but you still
have to reboot after stage 2.
Note that before stage 2 a kexec is initiated, not a reboot.
I haven't any idea why the interrupt for e1000e isn't available after the
kexec.
--
Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.