http://bugzilla.novell.com/show_bug.cgi?id=541396
User stevet@copper.net added comment
http://bugzilla.novell.com/show_bug.cgi?id=541396#c1
Steve Thompson changed:
What |Removed |Added
----------------------------------------------------------------------------
CC| |stevet@copper.net
--- Comment #1 from Steve Thompson 2009-10-18 15:03:44 MDT ---
Using CR1.
ISO burned to DVD. Boot from DVD and expected splash screen is given. Finally
selection to boot from hard drive... If ANY option is taken besides boot from
hard drive (I didn't test this one), the load fails.
This failure is seen by the screen not only going dark, but in my case, the
status light to the LCD unit shows loss of signal. IF you select TEXT for the
display, a series of modules being loaded shows, and then the whole thing hangs
(last 2 modules listed:
[ 0.184001] [<ffffffff819d80b0>] kernel_init+0x102/0x15c
[ 0.184001] [<ffffffff8100d6ca>] child_rip+0xa/0x20.)
So using a 11.1 64bit install DVD, here is the hardware config:
2x AMD Athlon 64 Dual Core 4200+
896MB Ram
ATI RS690 (Radeon X1200 Series)
ATI SB600 IDE
ATI SB600 Non-Raid-5 SATA
Dual 500GB SATA drives (with /home being RAID1)
Reason for testing this, problems found with 11.0-1 in the set up of RAID1
while doing install. Seems that GRUB is not correctly configured. As you can
see, I didn't get that far this time.
--
Configure bugmail: http://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.