Mailinglist Archive: opensuse-bugs (9006 mails)

< Previous Next >
[Bug 425480] e1000e fails to load
  • From: bugzilla_noreply@xxxxxxxxxx
  • Date: Tue, 23 Sep 2008 12:30:12 -0600 (MDT)
  • Message-id: <20080923183012.D2E0B245390@xxxxxxxxxxxxxxxxxxxxxx>
https://bugzilla.novell.com/show_bug.cgi?id=425480

User kkeil@xxxxxxxxxx added comment
https://bugzilla.novell.com/show_bug.cgi?id=425480#c49





--- Comment #49 from Karsten Keil <kkeil@xxxxxxxxxx> 2008-09-23 12:30:12 MDT
---
I could write the MAC address with ethtool but now the driver do not load
completely insmod hangs for about a minute and then it disable the IRQ.
After this here is no eth1 this are the dmesg:
e1000e: Intel(R) PRO/1000 Network Driver - 0.2.0
e1000e: Copyright (c) 1999-2007 Intel Corporation.
ACPI: PCI Interrupt 0000:00:19.0[A] -> GSI 20 (level, low) -> IRQ 20
PCI: Setting latency timer of device 0000:00:19.0 to 64
ACPI: PCI interrupt for device 0000:00:19.0 disabled
e1000e: Intel(R) PRO/1000 Network Driver - 0.2.0
e1000e: Copyright (c) 1999-2007 Intel Corporation.
ACPI: PCI Interrupt 0000:00:19.0[A] -> GSI 20 (level, low) -> IRQ 20
PCI: Setting latency timer of device 0000:00:19.0 to 64
ACPI: PCI interrupt for device 0000:00:19.0 disabled

I think, now with a valid checksum it interprets some of the still 0xFF values
as valid and set some registers wrong.


--
Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.

< Previous Next >
This Thread
References