https://bugzilla.novell.com/show_bug.cgi?id=331604#c16
--- Comment #16 from Thomas Fehr 2007-10-26 02:39:53 MST ---
For the DEVICE line, AFAIK also DEV and DEVICES are fine.
If you have real device names in DEVICE line your should replace them with
the string "partitions". This makes mdadm scan /proc/partitions for devices
to examine. If you use the special string partitions instead of device names
in the DEVICE line of mdadm.conf changing disk names will not affect your raid
setup. YaST2 uses "DEVICE partitions" since SL 10.1 so only systems older than
that chould still contain DEVICE lines with real partition names.
Regarding disk renaming, I would expect the following mapping from 10.2 to
10.3:
hda->sda
hdc->sdb
sda->sdc
sdb->sdd
--
Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.