https://bugzilla.novell.com/show_bug.cgi?id=230432#c12
--- Comment #12 from Peter van Hoof 2007-10-22 11:16:25 MST ---
OK, I have upgraded the system to 10.3 now. Setting up the gfx driver was a bit
of a disaster though. sax2 did not work at all, so I had to copy the old
xorg.conf from the 10.2 installation (which obviously was set up for i810).
That seemed to work, but 3D acceleration was disabled. I then decided to switch
to the new intel driver. I hand-edited the xorg.conf file to change i810 ->
intel and then configured the driver from YaST2 administrator settings. After
some switching back and forth and rerunning the configuration I could
eventually get it in the correct resolution, but still no 3D acceleration! Some
googling suggests that I am not the only one with this particular problem, so I
will assume that the driver is to blame. As long as this problem is not fixed I
obviously cannot say anything about the problem reported above.
--
Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.