https://bugzilla.novell.com/show_bug.cgi?id=326325#c9
Lukas Ocilka changed:
What |Removed |Added
----------------------------------------------------------------------------
CC| |ke@novell.com
--- Comment #9 from Lukas Ocilka 2007-09-26 07:00:59 MST ---
This seems to be a problem of updating new libzypp to even newer libzypp.
This feature was about "Enable sources during installation".
How is it done?
* At first, inst_upgrade_urls script reads the old format of repositories
(as they were used in 10.1 and 10.2)
* If they don't exist, it reads the new format (10.3)
* Then, these repositories are offered to user to have them enabled or
disabled during installation.
* After that, these repositories are added.
* At the end of the installation, all sources are stored to the target.
1.) Upgrade 10.2 -> 10.3
It is safe, because the old sources were in a different location.
New libzypp then reads only the newly enabled/disabled sources
2.) Upgrade 10.3 -> 10.3
Libzypp already uses the new format of sources.
After upgrade (second stage/reboot), the new sources are added as
wanted by user (enabled/disabled) during the installation ... and
they also stay there as they were enabled/disabled before the upgrade.
Stano suggests adding a note into the release notes.
3.) 10.3 -> 11.0
Probably the same as 10.3 -> 10.3 but we have to solved it well.
The second case cannot be fixed by other way than a hack, such as removing the
sources from disk just after the upgrade starts.
--
Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email
------- You are receiving this mail because: -------
You are on the CC list for the bug.