https://bugzilla.novell.com/show_bug.cgi?id=327017#c15 darren winter <sgt-d@sodpit.com> changed: What |Removed |Added ---------------------------------------------------------------------------- CC| |sndirsch@novell.com Status|RESOLVED |REOPENED Resolution|FIXED | --- Comment #15 from darren winter <sgt-d@sodpit.com> 2007-09-23 16:25:34 MST --- i need to reopen this bug. the vt switching problem is definitely caused by sax2 when it saves the xorg.conf during installation. i did a clean install of rc1 onto a different drive (sata). default xorg.conf (xorg.conf.install / xorg.conf.saxsave): Section "InputDevice" Driver "kbd" Identifier "Keyboard[0]" Option "Protocol" "Standard" Option "XkbRules" "xfree86" Option "XkbKeycodes" "xfree86" Option "XkbModel" "pc104" Option "XkbLayout" "us" EndSection after sax2 saves the xorg.conf Section "InputDevice" Driver "kbd" Identifier "Keyboard[0]" Option "Protocol" "Standard" Option "XkbLayout" "us" Option "XkbModel" "microsoft" Option "XkbRules" "xfree86" Option "XkbVariant" "nodeadkeys" EndSection the "Option "XkbVariant" "nodeadkeys"" line is the direct cause of my problem. with that line, i cannot switch vt's using ctrl+alt+fkey, and print screen also fails. if i comment that line and restart x, all keys work normally. this problem may have existed prior to rc1, but my sax2 in all previous versions failed due to a known problem with the logitech g5 mouse, so sax2 never saved an xorg.conf. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug.