https://bugzilla.novell.com/show_bug.cgi?id=256212 ------- Comment #6 from jimomura@pathcom.com 2007-03-22 14:38 MST ------- This is likely to be my last comment on this issue for the forseeable future: 1. I said previously that there seemed to be a Type or Cast error. As far as I can tell, I was wrong. On further investigation, I found that I had misunderstood some of the data calculations. As far as I know, the programs were running correctly. If I find out otherwise in the future, I will, of course post that information, but for now, I have no reason to believe the programs are incorrect. 2. The current version of "lm-sensors" in OpenSuSE 10.2 is "2.10.1-5". The data supporting the Winbond "w83627ehf" which connects the sensors on the my board was updated in lm-sensors 2.10.2, and the ATI SB600 (used in my board) chip support was defined in the very latest lm-sensors 2.10.3, which is just now in the process of being released. As such, I think my own next step is to wait for the release of lm-sensors 2.10.3 (which will be any-day-now) and then start over again at that point. In fact, I might just wait a while and see if you guys are going to update the "sensors" package for OpenSuSE 10.2. I expect that the "sensors.conf" file for 2.10.3 will be backwards compatible, and if it works with the current programs, I might just use that much as a new starting point for my adjustments -- unless you guys put out a new package. In that case I will start from whatever is in the updates. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.