https://bugzilla.novell.com/show_bug.cgi?id=226044 Summary: HAL doesn't recognize my SCSI scanner Product: openSUSE 10.2 Version: RC 5 Platform: i386 OS/Version: SuSE Other Status: NEW Severity: Normal Priority: P5 - None Component: Hotplug AssignedTo: dkukawka@novell.com ReportedBy: jsmeix@novell.com QAContact: qa@suse.de I have the following SCSI scanner: lsscsi -c (note that the vendor entry is empty for this device) ------------------------------------------------------------------------------ Host: scsi0 Channel: 00 Target: 06 Lun: 00 Vendor: Model: ScanMaker X12USL Rev: 1.30 Type: Scanner ANSI SCSI revision: 02 ------------------------------------------------------------------------------ lsscsi -v ------------------------------------------------------------------------------ [0:0:6:0] scanner ScanMaker X12USL 1.30 - dir: /sys/bus/scsi/devices/0:0:6:0 [/sys/devices/platform/host0/target0:0:6/0:0:6:0] ------------------------------------------------------------------------------ I have the following SCSI host adapter lspci -v ------------------------------------------------------------------------------ 02:0b.0 SCSI storage controller: Advanced System Products, Inc ABP940-U / ABP960-U (rev 03) Subsystem: Advanced System Products, Inc ASC1300 SCSI Adapter Flags: bus master, medium devsel, latency 64, IRQ 169 I/O ports at b800 [size=256] Memory at feafec00 (32-bit, non-prefetchable) [size=256] Expansion ROM at 30000000 [disabled] [size=64K] ------------------------------------------------------------------------------ which is recognized by HAL but there is nothing in "lshal" about my SCSI scanner. The SCSI kernel module for the host adapter is advansys. It was not automatically set up and therefore I did it manually so that it is loaded during boot via /etc/sysconfig/kernel ------------------------------------------------------------------------------ INITRD_MODULES="processor thermal advansys piix fan jbd ext3 edd" ------------------------------------------------------------------------------ By the way: The scanner works fine. -- Configure bugmail: https://bugzilla.novell.com/userprefs.cgi?tab=email ------- You are receiving this mail because: ------- You are on the CC list for the bug, or are watching someone who is.