Hi,
I'm using the following profile for the bootloader:
<bootloader>
<global>
<key>append</key>
<value>vga=0x0301 apic apm=power-off splash=0</value>
</global>
/dev/hda
lilo
<location>custom</location>
vga=0x0301 apic apm=power-off splash=0
</bootloader>
Two errors occur:
1) I'm using the global append entry and kernel_parameters, because
later I remove all append-lines from the sections (in a post-install
script) to have just one global append line. However, to get my
parameters in for the first reboot, kernel_parameters is needed, too,
because autoyast always creates append lines per section in lilo.conf.
So the global append is useless until the section append-lines are
removed, however, I want to include it already here.
This worked with earlier versions, but with 10.0RC1 no append line
is created in the global section of the lilo.conf.
2) autoyast creates a "default" entry without a rhs, i.e. the lilo.conf
contains
...
default
...
causing autoyast to complain it could not setup the bootloader.
cu,
Frank
--
Dipl.-Inform. Frank Steiner Web: http://www.bio.ifi.lmu.de/~steiner/
Lehrstuhl f. Bioinformatik Mail: http://www.bio.ifi.lmu.de/~steiner/m/
LMU, Amalienstr. 17 Phone: +49 89 2180-4049
80333 Muenchen, Germany Fax: +49 89 2180-99-4049
* Rekursion kann man erst verstehen, wenn man Rekursion verstanden hat. *