Since cloning a partition setup with the autoyast GUI isn't possible I
tried to do it by hand.
I want 1 GB swap on /dev/hda1, 20 GB / on /dev/hda2 and the
rest as /home on /dev/hda3. Setting it up with autoyast will result in
the config down below and the error message 'could not set up swap
partition on /dev/hda1' during install. Only thing I added was the
part but it also fails without it.
Is see more configuration problems arising as I want to use lprng, not
cups. How do I configure printers with autoyast2 GUI without using cups ?
I guess its not possible ?
Please point me to some complete autoyast documentation. All
I have now is the 66 page AutoYaST pdf which is very scarse and I don't
want to swamp the mailing list with my newbie questions.
Here is the config.xml part which will fail to set up swap :
<partitioning config:type="list">
<drive>
<device>/dev/hda</device>
<initialize config:type="boolean">false</initialize>
<partitions config:type="list">
<partition>
<crypt>twofish256</crypt>
<format config:type="boolean">false</format>
false
<mount>swap</mount>
130
1
primary
<size>1gb</size>
</partition>
<partition>
<crypt>twofish256</crypt>
<filesystem config:type="symbol">reiser</filesystem>
<format config:type="boolean">true</format>
false
<mount>/</mount>
131
2
primary
<size>20gb</size>
</partition>
<partition>
<crypt>twofish256</crypt>
<filesystem config:type="symbol">reiser</filesystem>
<format config:type="boolean">true</format>
false
<mount>/home</mount>
131
3
primary
<size>max</size>
</partition>
</partitions>
<use>all</use>
</drive>
</partitioning>
--
Henrik Schmidt Christian-Albrechts-Universitaet zu Kiel
Institut fuer Informatik +49 (431) 880 75 - 50 Fax or 43 Phone
Olshausenstr. 40 http://www.ks.informatik.uni-kiel.de
24098 Kiel, Germany email: hbs@ks.informatik.uni-kiel.de